Abstract:Radiation sensors based on the heating effect of the absorbed radiation are typically relatively simple to operate and flexible in terms of the input frequency. Consequently, they are widely applied, for example, in gas detection, security, THz imaging, astrophysical observations, and medical applications. A new spectrum of important applications is currently emerging from quantum technology and especially from electrical circuits behaving quantum mechanically. This circuit quantum electrodynamics (cQED) has given rise to unprecedented single-photon detectors and a quantum computer supreme to the classical supercomputers in a certain task. Thermal sensors are appealing in enhancing these devices since they are not plagued by quantum noise and are smaller, simpler, and consume about six orders of magnitude less power than the commonly used traveling-wave parametric amplifiers. However, despite great progress in the speed and noise levels of thermal sensors, no bolometer to date has proven fast and sensitive enough to provide advantages in cQED. Here, we experimentally demonstrate a bolometer surpassing this threshold with a noise equivalent power of $30\, \rm{zW}/\sqrt{\rm{Hz}}$ on par with the current record while providing two-orders of magnitude shorter thermal time constant of 500 ns. Importantly, both of these characteristic numbers have been measured directly from the same device, which implies a faithful estimation of the calorimetric energy resolution of a single 30-GHz photon. These improvements stem from the utilization of a graphene monolayer as the active material with extremely low specific heat. The minimum demonstrated time constant of 200 ns falls greatly below the state-of-the-art dephasing times of roughly 100 {\mu}s for superconducting qubits and meets the timescales of contemporary readout schemes thus enabling the utilization of thermal detectors in cQED.

Enhanced sensitivity of sub-THz thermomechanical bolometers exploiting vibrational nonlinearity

Wide-Range Bolometer with RF Readout TES

High-sensitivity transition-edge-sensed bolometers: improved speed and characterization with AC and DC bias

Thermoelectric bolometers based on ultra-thin heavily doped single-crystal silicon membranes

Beating thermal noise in a dynamic signal measurement by a nanofabricated cavity optomechanical sensor

Nano-thermoelectric infrared bolometers

Dual-Mode Thermal-Piezoresistive Coupled Resonators for Fast and Stable NIR Measurements with Differential Output

Bolometer operating at the threshold for circuit quantum electrodynamics

Single MoS2-flake as a high TCR non-cryogenic bolometer

Demonstration of ultra-low noise equivalent power using a longitudinal proximity effect transition-edge sensor

Significant noise improvement in a Kinetic Inductance Phonon-Mediated detector by use of a wideband parametric amplifier

Development of highly sensitive nanoscale transition edge sensors for gigahertz astronomy and dark matter search

Strong Negative Electrothermal Feedback in Thermal Kinetic Inductance Detectors

Operation of a Wideband Terahertz Superconducting Bolometer Responding to Quantum Cascade Laser Pulses

Monolithically integrated mid-infrared sensor using narrow mode operation and temperature feedback

Overcoming Thermo-Optical Dynamics in Broadband Nanophotonic Sensing

Investigating thermal properties of 2D non-layered material using a NEMS-based 2-DOF approach towards ultrahigh-performance bolometer

On Enhancing the Sensitivity of Resonant Thermometers Based on Parametric Modulation

Cryogenic sensor enabling broad-band and traceable power measurements

Fabrication of phononic filter structures for far-IR/sub-mm detector applications

Thermoelectric thermal detectors based on ultra-thin heavily doped single-crystal silicon membranes