Abstract:The Solar Neutrino and Astro-Particle PhYsics (SNAPPY) Cubesat is expected to launch in 2025 and it will carry into a polar orbit a prototype test detector for solar neutrino background studies while over the Earth's poles for the neutrino Solar Orbiting Laboratory future project ($\nu$SOL). During this flight it is possible to do other science measurements. One of these is an improved study of the solar wind particles through improved particle identification and energy measurements. This study aimed to understand how well could the solar wind particles be identified using the planned detector but instead of using the veto array as an anti-coincidence it would be used as a $\Delta$E energy sampling of a phoswich particle ID system.

What problem does this paper attempt to address?

The main problem this paper attempts to address is: improving the study of solar wind particles through enhanced particle identification and energy measurement methods. Specifically, the research aims to evaluate whether the planned CubeSat detector (for the νSOL project) can effectively use the ΔE-E method to identify solar wind particles and measure their energy. ### Background and Motivation 1. **νSOL Project**: The primary goal of this project is to detect and study neutrinos from the Sun. To achieve this, the CubeSat detector will enter a polar orbit to conduct neutrino background research. 2. **Detector Design**: The CubeSat detector contains two different detection materials: Polyethylene Terephthalate (Veto) and Gallium Aluminum Gallium Garnet (GAGG). The GAGG crystal is surrounded by Veto, used to measure the interaction of neutrinos with 71Ga. The role of Veto is to filter out non-neutrino signals. 3. **Solar Wind Particle Research**: In addition to neutrino research, the CubeSat detector can also be used for other scientific studies, particularly the study of solar wind particles. The energy and composition of solar wind particles are crucial for understanding solar activity and space weather. ### Research Objectives 1. **Particle Identification**: Evaluate the ability of the CubeSat detector to identify solar wind particles using the ΔE-E method. 2. **Energy Measurement**: Measure the energy spectrum of solar wind particles. 3. **Simulation Verification**: Use GEANT4 software for Monte Carlo simulations to verify the detector's performance under different scenarios. ### Methods 1. **ΔE-E Method**: The ΔE-E method is a commonly used particle identification technique that distinguishes different types of particles by measuring their energy deposition in different detectors. 2. **Detector Geometry**: The geometry of the CubeSat detector differs from traditional ΔE-E telescopes, with the GAGG crystal completely surrounded by Veto, which may lead to deviations in the energy deposition curve. 3. **Simulation Scenarios**: Various simulation scenarios were designed, including pencil beam, planar incidence, hemispherical isotropic distribution, and spherical isotropic distribution, to evaluate the detector's performance under different conditions. ### Results 1. **Energy Deposition Maps**: Showed the energy deposition of different particles in the detector, verifying the detector's ability to identify certain light particles (such as electrons, protons, and α particles). 2. **Particle Identification**: For heavier particles (such as carbon, nitrogen, oxygen, and neon), the ΔE-E method was less effective, with significant overlap in the energy deposition regions within the detector. 3. **Geometric Effects**: The special geometry of the detector led to some deviations in the energy deposition curves, but overall did not affect the accuracy of particle identification. ### Conclusion 1. **Feasibility**: The study shows that the CubeSat detector can effectively use the ΔE-E method to identify light particles in the solar wind and measure their energy spectrum. 2. **Limitations**: For heavier particles, the ΔE-E method is limited and requires further research and optimization. 3. **Application Prospects**: This research provides important references for future solar wind particle studies, contributing to a better understanding of solar activity and space weather. Through these studies, the paper provides a theoretical foundation and technical support for the application of the CubeSat detector in solar wind particle research.

Simulation of Solar Wind Charged Particle Energy Deposited and Particle Identification by $Δ$E-E Discrimination in the SNAPPY Cubesat Detector

Design and Testing of a 3U CubeSat to Test the In-situ Vetoing for the $ν$SOL Solar Neutrino Detector

The Energetic Particle Detector-Energetic Particle Instrument Suite for the Solar Orbiter Mission

The Energetic Particle Detector

Solar Energetic Particle Time Series Analysis with Python

Prototype of a segmented scintillator detector for particle flux measurements on spacecraft

Concept for a Space-based Near-Solar Neutrino Detector

A Background Suppression Detector Array for Fast Neutron Measurement in Space Science Study

Design of an Interplanetary Ultralow-Noise Three-Dimensional Energetic Particle Spectrometer

Scientific Goals and In-orbit Performance of the High-energy Particle Detector on Board the CSES

The electronics of the HEPD of the CSES experiment

Advances in Energetic Particle Physics with Solar Orbiter

Energetic Electron Detection Packages on Board Chinese Navigation Satellites in MEO

Scintillator-SiPM Detector for Tracking and Energy Deposition Measurements

Reflections of ions in electrostatic analyzers: a case study with New Horizons/Solar Wind Around Pluto

Physics-Based Simulation of the 2013 April 11 SEP Event

A Statistical Study of Solar Particle Events in Flux and Dose

Gamma Ray Detection Efficiency of GAGG Crystal Scintillator Using Three Tagged Gamma Ray Techniques

Multispacecraft Observations of Protons and Helium Nuclei in Some Solar Energetic Particle Events toward the Maximum of Cycle 25

SIMULATION OF ENERGETIC NEUTRAL ATOMS FROM SOLAR ENERGETIC PARTICLES

On the seed population of solar energetic particles in the inner heliosphere