Abstract:A detailed assessment of the thermo-mechanical limits of the ITER divertor with respect to potential excessive local transient heat loads due to Edge Localised Modes (ELMs) has revealed a particular power loading scenario arising from the fact that ELM ions expelled from the upstream pedestal region will arrive at the divertor target plates without substantial thermalisation. As a consequence of their Larmor gyration around magnetic field lines, they are able to penetrate toroidal gaps between individual monoblocks of the target plate structure and can deliver rather intense heat loads to monoblock side faces near the gap entrance. To verify that this ELM-induced loading, predicted by both ion orbit simulations and particle in cell simulations, really does occur, two dedicated experiments have been performed on the ASDEX Upgrade tokamak. In both experiments a model toroidal gap structure of similar dimensions to those of the ITER divertor target monoblocks was exposed to a series of identical H-mode discharges with strong type-I ELMs. The effects arising from the gyro motion of hot ELM ions were identified by inverting, in the second experiment, the directions of both toroidal field and plasma current, thus reversing the ion gyration direction. The local distribution of incident ion flux on the gap side faces was quantified by pre- and post-exposure analysis of platinum marker layers to determine quantitatively the erosion rate of the platinum marker. The results fully confirm the ion orbit code predictions with respect to the penetration depth of incident ions with gyro orbits of similar or larger radius than the gap width. Moreover, the results confirm that ELM ions do indeed arrive at the divertor with their typical pedestal energies and also allow conclusions to be drawn regarding the corresponding intra-ELM ion particle and power flux, which is not easy to quantify using Langmuir probes.

Ion Temperature Measurements in the MAST-U Divertor During Steady State Plasmas and ELM Burn Through Phenomena

First Ion Temperature Measurements in the MAST-U Divertor via Retarding Field Energy Analyzer

Electric Probe Measurements at Edge Region During H‐Mode Discharges in KSTAR

Scrape-off layer ion temperature measurements at the divertor target during type III and type I ELMs in MAST measured by RFEA

Divertor Heat Flux Mitigation Using Supersonic Molecular Beam Injection in Type-Iii Elmy H Mode Plasmas of Hl-2a Tokamak

Divertor heat fluxes and profiles during mitigated and unmitigated Edge Localised Modes (ELMs) on the Mega Amp Spherical Tokamak (MAST)

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Investigation of pedestal parameters and divertor heat fluxes in small ELM regimes on DIII-D

Investigation of ELM-related Larmor ion flux into toroidal gaps of divertor target plates

First 2D electron density measurements using Coherence Imaging Spectroscopy in the MAST-U Super-X divertor

Measurement of the Edge Ion Temperature in W7-X with Island Divertor by a Retarding Field Analyzer Probe

Evolution of radiation profiles in a strongly baffled divertor on MAST Upgrade

Electron and Ion Heating Characteristics during Magnetic Reconnection in the MAST Spherical Tokamak

Electron and ion heating characteristics during magnetic reconnection in MAST

Comparison of Measurements with Different Types of Divertor Langmuir Probe in EAST Tokamak

2D electron density profile evolution during detachment in Super-X divertor L-mode discharges on MAST-U

Experimental Observation of Heat Flux Mitigation During Divertor Detachment in the DIII-D Small Angle Slot Divertor

Resolving Interactions Between Ion-Cyclotron Range of Frequencies Heating and the Scrape-off Layer Plasma in EAST Using Divertor Probes

Study of Divertor Heat Flux Widths in Type-I Elmy H-Mode with Infra-Red Thermography on East Tokamak

Initial Fulcher band observations from high resolution spectroscopy in the MAST-U divertor

Boundary Ion Temperatures and Ion Orbit Losses in JET