Abstract:Superconducting qubits typically use a dispersive readout scheme, where a resonator is coupled to a qubit such that its frequency is qubit-state dependent. Measurement is performed by driving the resonator, where the transmitted resonator field yields information about the resonator frequency and thus the qubit state. Ideally, we could use arbitrarily strong resonator drives to achieve a target signal-to-noise ratio in the shortest possible time. However, experiments have shown that when the average resonator photon number exceeds a certain threshold, the qubit is excited out of its computational subspace in a process we refer to as a measurement-induced state transition (MIST). These transitions degrade readout fidelity, and constitute leakage which precludes further operation of the qubit in, for example, error correction. Here we study these transitions experimentally with a transmon qubit by measuring their dependence on qubit frequency, average resonator photon number, and qubit state, in the regime where the resonator frequency is lower than the qubit frequency. We observe signatures of resonant transitions between levels in the coupled qubit-resonator system that exhibit noisy behavior when measured repeatedly in time. We provide a semi-classical model of these transitions based on the rotating wave approximation and use it to predict the onset of state transitions in our experiments. Our results suggest the transmon is excited to levels near the top of its cosine potential following a state transition, where the charge dispersion of higher transmon levels explains the observed noisy behavior of state transitions. Moreover, we show that occupation in these higher energy levels poses a major challenge for fast qubit reset.

Fast Unconditional Reset and Leakage Reduction of a Tunable Superconducting Qubit via an Engineered Dissipative Bath

Rapid and unconditional parametric reset protocol for tunable superconducting qubits

Fast unconditional reset and leakage reduction in fixed-frequency transmon qubits

Multi-Purpose Architecture for Fast Reset and Protective Readout of Superconducting Qubits

Many-excitation removal of a transmon qubit using a single-junction quantum-circuit refrigerator and a two-tone microwave drive

High-fidelity gates in a transmon using bath engineering for passive leakage reset

Measurement-Induced State Transitions in a Superconducting Qubit: Within the Rotating Wave Approximation

Scalable quantum eraser for superconducting integrated circuits

Thermally driven quantum refrigerator autonomously resets superconducting qubit

Active Initialization Experiment of Superconducting Qubit Using Quantum-circuit Refrigerator

Optimizing resetting of superconducting qubits

Active reset of superconducting qubits using the electronics based on RF switches

Dispersive Qubit Readout with Intrinsic Resonator Reset

Optimally Fast Qubit Reset

Methods to achieve near-millisecond energy relaxation and dephasing times for a superconducting transmon qubit

Suppression of quasiparticle poisoning in transmon qubits by gap engineering

On-demand driven dissipation for cavity reset and cooling

Engineering a multi-level bath for transmon with three-wave mixing and parametric drives

Gatemon Qubit Revisited for Improved Reliability and Stability

Dissipative preparation and stabilization of many-body quantum states in a superconducting qutrit array