Optimal Kinematics for Energy Harvesting Using Favorable Wake-Foil Interactions in Tandem Oscillating Hydrofoils

Eric E. Handy-Cardenas,Yuanhang Zhu,Kenneth S. Breuer
2024-11-01
Abstract:The energy harvesting performance of a pair of oscillating hydrofoil turbines in tandem configuration is experimentally studied to determine the optimal kinematics of the array. By characterizing interactions between the wake produced by the leading foil and the trailing foil, the kinematic configuration required to maximize array power extraction is determined. This is done by prescribing leading foil kinematics that produce specific wake regimes, identified by the maximum effective angle of attack parameter. The kinematics of the trailing foil are allowed to vary significantly from those of the leading foil. The heave and pitch amplitude, inter-foil phase, and foil separation of the trailing foil are varied within each wake regime and the system performance is evaluated. The power extracted by each foil over an oscillation cycle is measured through force and torque measurements. Wake-foil interactions that yield improvements in trailing foil performance are analyzed with time-resolved Particle Image Velocimetry. Constructive and destructive wake-foil interactions are compared, and it was determined that trailing foil performance could be improved by either avoiding interactions with wake vortices or by interacting directly with them. The latter configuration takes advantage of the wake vortex, and does not see power loss during the oscillation cycle. System power from the two foils is maximized when the leading foil is operated at an intermediate maximum angle of attack range, and when the trailing foil avoids collisions with wake vortices. This optimal array configuration sees both foils operating with different kinematics compared to the optimal kinematics for a single oscillating foil.
Fluid Dynamics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: how to maximize the energy harvesting efficiency by optimizing the dynamic parameters of an oscillating hydrofoil array. Specifically, the researchers experimentally studied the performance of two oscillating hydrofoils in a tandem configuration under different dynamic parameters to determine the optimal dynamic configuration, thereby maximizing the overall energy harvesting efficiency of the system. ### Research Background and Objectives With the increasing demand for sustainable energy, tidal energy has received more and more attention due to its high predictability and abundant resources. Oscillating Foil Turbines (OFTs), as a potential tidal - stream energy extraction device, their performance has been widely concerned. However, the performance of a single hydrofoil has been well characterized, while the performance optimization in an array configuration remains an important research direction. ### Main Research Contents 1. **Experimental Setup**: - The experiment was carried out in a circulating water channel. The cross - sectional dimension of the test section was 0.8 m × 0.6 m, and the length was 4 m. - Two rectangular flat - plate hydrofoils were used and installed vertically in the flow. - The up - and - down movement and pitching movement of the hydrofoils were controlled by servo motors. - Force and torque data were recorded by a six - axis force/torque sensor. - The flow field was measured using Particle Image Velocimetry (PIV). 2. **Dynamic Parameters**: - The main dynamic parameters include: dimensionless lift amplitude \( h_0^* \), dimensionless frequency \( f^* \), phase difference between the front and rear hydrofoils \( \psi_{1 - 2} \) and the spacing between the front and rear hydrofoils \( S_x \). - Through different combinations of these parameters, the researchers evaluated the performance of the system under different configurations. 3. **Performance Evaluation**: - Through force and torque measurements, the power extracted by each hydrofoil within one oscillation cycle was calculated. - The influence of wake - hydrofoil interaction was analyzed using PIV technology. - The system performance under different configurations was compared to determine the optimal dynamic configuration. ### Key Findings - **Optimal Dynamic Configuration**: - When the leading hydrofoil operates under the intermediate - range \( \alpha_{T/4} \) value and the following hydrofoil avoids colliding with the wake vortices, the overall performance of the system is the best. - Under the optimal configuration, the dynamic parameters of the leading hydrofoil and the following hydrofoil are different, which is different from the optimal dynamic configuration of a single hydrofoil. - **Wake - Hydrofoil Interaction**: - The constructive and destructive wake - hydrofoil interactions have a significant impact on the performance of the following hydrofoil. - By directly interacting with the wake vortices, the performance of the following hydrofoil can be improved without causing power loss within the oscillation cycle. ### Conclusion This research, through experiments and PIV measurements, has explored in detail the influence of the dynamic parameters of a tandem - oscillating - hydrofoil array on the energy harvesting efficiency. The research results show that by optimizing the dynamic parameters of the front and rear hydrofoils, the overall performance of the system can be significantly improved, providing an important reference for the design of future tidal - energy extraction devices.