Toolpath Generation for High Density Spatial Fiber Printing Guided by Principal Stresses

Tianyu Zhang,Tao Liu,Neelotpal Dutta,Yongxue Chen,Renbo Su,Zhizhou Zhang,Weiming Wang,Charlie C.L. Wang

2024-10-22

Abstract:While multi-axis 3D printing can align continuous fibers along principal stresses in continuous fiber-reinforced thermoplastic (CFRTP) composites to enhance mechanical strength, existing methods have difficulty generating toolpaths with high fiber coverage. This is mainly due to the orientation consistency constraints imposed by vector-field-based methods and the turbulent stress fields around stress concentration regions. This paper addresses these challenges by introducing a 2-RoSy representation for computing the direction field, which is then converted into a periodic scalar field to generate partial iso-curves for fiber toolpaths with nearly equal hatching distance. To improve fiber coverage in stress-concentrated regions, such as around holes, we extend the quaternion-based method for curved slicing by incorporating winding compatibility considerations. Our proposed method can achieve toolpaths coverage between 87.5% and 90.6% by continuous fibers with 1.1mm width. Models fabricated using our toolpaths show up to 84.6% improvement in failure load and 54.4% increase in stiffness when compared to the results obtained from multi-axis 3D printing with sparser fibers.

Graphics,Computational Geometry

What problem does this paper attempt to address?

This paper attempts to address the issue of generating high-density fiber paths in the multi-axis 3D printing process of Continuous Fiber Reinforced Thermoplastic Composites (CFRTP). Specifically, existing methods struggle to generate tool paths with high fiber coverage, mainly due to the requirements of direction consistency constraints in vector field-based methods and the influence of turbulent stress fields around stress concentration areas. To solve these problems, the paper proposes a new method that calculates the direction field by introducing 2-RoSy representation and converts it into a periodic scalar field, thereby generating nearly equidistant fiber paths. Additionally, to improve fiber coverage in stress concentration areas (such as around holes), the paper extends quaternion-based methods to consider winding compatibility. Experimental results show that the tool paths generated using this method can significantly enhance the mechanical strength and stiffness of the composites.

### Main Contributions of the Paper:
1. **2-RoSy Representation**: Introduced 2-RoSy representation to calculate optimized direction fields, eliminating direction ambiguity and aligning with the maximum principal stress direction.
2. **Periodic Scalar Field**: Developed a method to convert 2-RoSy direction fields into periodic scalar fields, generating nearly equidistant fiber paths and achieving high-density fiber arrangement.
3. **Winding Compatibility**: Extended quaternion-based methods to consider winding compatibility, improving fiber coverage in stress concentration areas.

### Experimental Validation:
- Mechanical tests were conducted using a newly designed print head to verify the effectiveness of the generated fiber paths.
- Scanning Electron Microscope (SEM) images further analyzed the failure of CFRTP composites, validating the improvement in mechanical strength.

### Summary:
This paper proposes a new method that optimizes the generation of direction fields and periodic scalar fields, addressing the challenges faced by existing methods in generating high-density fiber paths, and significantly improving the mechanical performance of CFRTP composites.