Development of quasi-optical system for the Doppler backscattering reflectometers on the MAST-U
Z. B. Shi,J. Wen,B. Wang,Z. C. Yang,W. L. Zhong,J. C. Hillesheim,S. Freethy,M. Jiang,P. W. Shi,K. R. Fang,Z. T. Liu,Min Xu
2019-01-01
Abstract:reflectometers on the MAST-U Z.B.Shi, J.Wen, B.Wang, Z.C.Yang, W.L.Zhong, J.C. Hillesheim, S. Freethy, M.Jiang, P.W.Shi, K.R.Fang, Z.T.Liu, and Min Xu Southwestern Institute of Physics, P. O. Box 432, Chengdu 610041, China University of Electronic Science and Technology of China. Chengdu 610054, China CCFE, Culham Science Centre, Abingdon, Oxon OX14 3DB, UK *Corresponding author’s e-mail address: shizb@swip.ac.cn Doppler backward scattering (DBS) reflectometer has become a powerful technique to study the plasma turbulence and transport through measurement of the perpendicular velocity of density fluctuations, their intensity, and the radial electric field in magnetically confined plasmas [1-2]. Two 8-channel (Q/V bands) DBS systems with the channel frequencies of (34, 36, 38, 40, 42, 44, 46, and 48) GHz and (52.5, 55, 57.5, 60, 62.5, 65, 67.5, and 70) GHz have been developed on the HL-2A tokamak [3]. They will be delivered to MAST-U to joint study the turbulence and plasma rotation in high confinement plasmas under the SWIP-CCFE collaboration before the end of 2019 [3-4]. This work describes characteristics of a novel quasi-optical system for the MAST-U DBS system. A focal lens and a rotatable polarizer are used to focus and rotate the polarization angle of the incident microwave from the Q-band and V-band systems. Due to the possible sensitivity of measurement interpretation to aspects of the components in quasi-optical system, detailed measurements to characterize them are presented. A small microwave beam in plasma is of crucial for the DBS measurement to get enough wavenumber sensitivity [5]. A novel quasi-optical system with a focal lens and a rotatable polarizer has been designed to focus and adjust the launching microwave beam. Figure 1 shows schematic diagram of the quasi-optical system. It was designed to implement the Q/V-band DBS systems due to the space limitation and port access constraints. The scalar horns (launcher and receiver) of each system are installed in the orthogonal positions. After the horns, the beams are combined via a rotatable polarizer, which can be adjusted to match the magnetic field pitch angle, so each system ideally operates in one linear polarization within the plasma. Due to 45 degree tilt arrangement, the linear polarized wave will be split and travel both ways: pass through and be reflected by the polarier, i.e. the polarizer grid is also acting as a 3 dB polarization coupler to combine/power-divide the launch and receive