Abstract:A practical method for identifying the propeller model and inertia matrix of a marine Autonomous Surface Vehicle (ASV) is proposed in this work. Special attention is paid to limiting the instrumentation requirements. Based on a generic grey-box dynamic modelling addressing the considered catamaran-shaped ASV architecture, the static/dynamic behaviour of both propellers and the vessel dynamic are jointly estimated using the sole measurements of position, heading, and propellers pulse width modulation (PWM) signals. No accelerometer is required. Two distinct grey-box configurations involving either a static polynomial or a dynamic modelling of each propeller are proposed and compared. The resulting ASV identification methodology is shown to provide insight into the whole vessel inertial characteristics, which are key enablers in the development of autonomous navigation and control systems. Model validation was performed using data collected from the reported experiments. Model prediction errors related to both linear velocities and yaw rate are evaluated and compared based on given metrics. The results underscore the robustness and accuracy of the identified models in capturing the essential dynamics of the ASV, with a determination coefficient that consistently exceeds 0.94 for all estimated velocities.

What problem does this paper attempt to address?

### What problems does this paper attempt to solve? This paper aims to solve the problems of propulsion dynamics and inertia matrix identification of Autonomous Surface Vehicles (ASV), especially with the use of the minimum number of sensors. Specifically, the paper proposes a practical method to identify the propeller model and inertia matrix of ASV without the need for complex instrumentation. #### Main problems: 1. **Joint estimation of propulsion system and ship dynamics**: Existing literature usually only focuses on the separate identification of ship dynamics or propulsion system, without considering the combined influence of both on vehicle motion at the same time. This paper attempts to jointly estimate the propulsion system and ship dynamics by minimizing the sensor requirements. 2. **Reducing dependence on complex sensors**: Traditional methods often require a large number of sensors, such as accelerometers, etc., which increases the cost and complexity of the system. The method proposed in this paper only requires position, heading and propeller PWM signals, without the need for accelerometers. 3. **Improving model accuracy**: Through experimental verification, ensure that the proposed model can accurately capture the key dynamic characteristics of ASV, thereby providing support for the development of autonomous navigation and control systems. #### Specific objectives: - Define and compare different grey - box models (non - linear, dynamic) applicable to the input gain \( G = G(\delta_L, \delta_R) \). - Estimate all relevant parameters. - Based on the given evaluation indicators, verify the final entire ASV dynamics model. #### Method overview: - Use the minimum sensor configuration (GNSS, AHRS and PWM signals). - Propose two different grey - box model configurations: static polynomial model and dynamic model. - Verify the validity of the model through experimental data and evaluate the model prediction error. Through these efforts, the paper hopes to provide theoretical and technical support for the development of more efficient, low - cost and reliable autonomous surface vehicles.

Practical identification approach for the actuation dynamics of autonomous surface vehicles with minimal instrumentation: extended version

Dynamic Modeling of a Lightweight Unmanned Underwater Vehicle: Sea-U-Dragon

Computational Fluid Dynamics Study of Autonomous Underwater Vehicle with Vectorial Thrusters

Dynamic Modeling of a Wave Glider

Modeling, Identification, and Control of an Unmanned Surface Vehicle

Parameter Identification of an Unmanned Sailboat Combining Experiments and Numerical Analysis

Dynamic Autonomous Surface Vehicle Controls Under Changing Environmental Forces

Dynamics modeling and performance evaluation of an autonomous underwater vehicle

An Underwater Integrated Navigation Method for Small Autonomous Surface and Underwater Vehicle

Experimental Dynamics Identification of Autonomous Underwater Vehicle and Modified Model Reference Adaptive Controller Design*

Advancing unmanned surface vehicle heading control: real-sea validation of a practical model predictive controller for a medium-scale hybrid-power trimaran

Design and Validation of a Course Control System for a Wave-Propelled Unmanned Surface Vehicle

State Estimation of Marine Vessels Affected by Waves by Unmanned Aerial Vehicles

Unmanned Surface Vehicle: Yaw Modeling and Identification

Dynamic Model Based Integrated Navigation for a Small and Low Cost Autonomous Surface/underwater Vehicle

Hydrodynamic Coefficient Estimation of Small Autonomous Underwater Vehicle

This is the Way: Mitigating the Roll of an Autonomous Uncrewed Surface Vessel in Wavy Conditions Using Model Predictive Control

A Study on Maneuverability of a New Concept Marine Vehicle

Online interactive identification method based on ESO disturbance estimation for motion model of double propeller propulsion unmanned surface vehicle

Dynamics Modeling and Simulation of a Small AUV Controlled by Thruster and Rudders

Physics-informed identification of marine vehicle dynamics using hydrodynamic dictionary library-inspired adaptive regression