Transient bubble rising in the presence of a surfactant at very low concentrations

D. Fernández-Martínez,M. G. Cabezas,J. M. López-Herrera,M. A. Herrada,J. M. Montanero

2024-09-24

Abstract:We study the formation of the dynamic adsorption layer when a bubble is released in a tank containing water with a tiny amount of surfactant. The influence of the sorption kinetic constants is examined by comparing the experiments with Sodium Dodecyl Sulfate (SDS) and Triton X-100. The experiments allowed us to determine the parameter conditions that lead to a stable bubble rising and to validate the simulation. A simple scaling analysis and the simulation show that the formation of the dynamic adsorption layer can be split into three phases characterized by disparate time scales. The mechanisms controlling those phases are surfactant convection, adsorption-desorption, and diffusion. The amount of surfactant adsorbed onto the interface increases monotonously throughout the three phases. The experiments and the simulation show that the rising velocity reaches a maximum at times of the order of $k_d^{-1}$ ($k_d$ is the desorption constant) when the dynamic adsorption layer is practically formed. This occurs even when only traces of surfactant are present in the liquid. The non-monotonous behavior of the maximum surfactant surface concentration is explained in terms of the reverse flow in the rear of the bubble right after the bubble release. This work contributes to the understanding of the complex interplay between hydrodynamics and surfactant transport and kinetics over bubble rising.

Fluid Dynamics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to understand the formation of the dynamic adsorption layer and its influence on the bubble behavior when the bubble rises in an aqueous solution containing a trace amount of surfactant. Specifically, the research aims to explore the following points:

1. **Formation mechanism of the dynamic adsorption layer**: When a bubble is released in a liquid containing a trace amount of surfactant, surfactant molecules will adsorb onto the bubble interface, forming a dynamic adsorption layer. This process can be divided into three stages, each with a different time scale, which are respectively controlled by the convection, adsorption - desorption and diffusion mechanisms of the surfactant.

2. **Change in the bubble rising speed**: Research shows that the rising speed of the bubble will reach a maximum at certain moments, which usually occurs when the dynamic adsorption layer is basically formed (that is, the time scale is approximately \( k_d^{-1} \), where \( k_d \) is the desorption constant). This phenomenon will occur even if the liquid contains only a trace amount of surfactant.

3. **Influence of surfactant concentration on bubble behavior**: Experimental and simulation results show that as the surfactant concentration increases, the maximum rising speed of the bubble, and the height and width of the speed curve will change. In addition, the presence of surfactant will also affect the trajectory stability of the bubble, resulting in spiral or zigzag motion.

4. **Verification of the numerical simulation method**: Determine the parameter conditions that can produce stable axisymmetric bubble rising through experiments, and verify the accuracy of the numerical simulation method. Two different surfactants - sodium dodecyl sulfate (SDS) and Triton X - 100 - were used in the experiment to compare their different effects on bubble behavior.

In short, this research aims to deeply understand the complex interaction between fluid mechanics and surfactant transport and dynamics when the bubble rises in a liquid containing a trace amount of surfactant. This understanding is of great significance for many industrial and technological processes involving gas - liquid interface mass transfer.