Abstract:Space debris has become a critical issue, with debris in orbit surpassing active satellites, posing significant risks to space sustainability. Payloads or rocket bodies discarded post-mission in LEO without orbital control are major sources. The IADC guidelines recommend limiting post-mission presence in protected regions to 25 years. The FCC recently introduced stricter regulations, reducing the allowable post-mission stay for LEO satellites to 5 years. These changes necessitate integrating deorbiting systems into satellite designs. However, adding extra fuel and engines for active deorbiting presents challenges due to LEO satellites' mass and volume limitations, especially for large constellations or CubeSats. This often leads to prioritizing mission-critical components over deorbiting systems. Thus, alternative approaches like passive deorbiting techniques or international regulations are explored. Drag sails are a cost-effective passive solution for small and medium-sized LEO satellites. This paper proposes a plug-and-play drag sail module using COTS components for CubeSats and sub-mass satellites. The scalable design is derived from mission requirements and trajectory analysis. The technique includes active control for quicker deorbiting at specific orbital LTAN. Inspired by JAXA's IKAROS mission, the deployment mechanism uses residual angular momentum and follows a standard sequence. A cost analysis estimates the system's breakeven point. A prototype with a 3D-printed deployment system and inverted stepper motor was tested and compared to a numerical model. A tension model for sail extension petals was developed using curve fitting from test data. SIMULINK multibody models are available for simulations. Further experimentation and prototype development are required to assess real-world performance, with a control system identified as crucial.

Estimation of inertial properties of a rigid structure maneuvered by satellite modules

A Scalable Tabletop Satellite Automation Testbed:Design And Experiments

Two-stage estimator for the complete inertia tensor of uncooperative debris on cubesat based active debris removal missions

Fault-Tolerant Position/Attitude Estimation of Free-Floating Space Objects Using a Laser Range Sensor

Parameters estimation of space debris captured by tethered robotic system

Proximity operations of CubeSats via sensor fusion of ultra-wideband range measurements with rate gyroscopes, accelerometers and monocular vision

Attitude Control For Flexible Spacecraft With Swinging Components

Estimate pose deviation of on-orbit deployable mechanisms based on cross-ratio invariability

On-Line Mass-Property Identification Algorithm Research For Satellite

Inertia Parameter Identification for an Unknown Satellite in Precapture Scenario

Adaptive Robot Detumbling of a Non-Rigid Satellite

Plug-and-Play Drag Sail Module for LEO Satellites: Implementation and Early Testing of AirDragMod (ADM)

Pose Measurement and Motion Estimation of Non-Cooperative Satellite Based on Spatial Circle Feature

In-Orbit Estimation of Inertia Parameters of Target Satellite after Capturing the Tracking Satellite

Maneuver-Aided Active Satellite Tracking Using Six-DOF Optimal Dynamic Inversion Control

Quick-response Attitude Takeover Control Using Multiple Servicing Spacecraft Based on Inertia Properties Identification

Circular-Feature-Based Pose Estimation of Noncooperative Satellite Using Time-of-Flight Sensor

Lidar Pose Tracking of a Tumbling Spacecraft Using the Smoothed Normal Distribution Transform

A Dynamic, Hardware-in-the-Loop, Three-Axis Simulator of Spacecraft Attitude Maneuvering with Nanosatellite Dimensions

Modeling of an On-Orbit Maintenance Robotic Arm Test-Bed

On-orbit identifying the inertia parameters of space robotic systems using simple equivalent dynamics