Abstract:Silicon represents one of the most promising anode materials for next generation lithium-ion batteries. However its colossal volume expansion (up to 300%) upon electrochemical reaction with lithium repeatedly exposes fresh surfaces to electrolyte solvent oxidation. This leads to very high irreversible capacities 1 . Deeper insight into these degradation phenomena is critical to engineer adequate electrodes and/or electrolytes. Little is known about the SEI’s morphology at the particle scale. Attempts to characterize this system through transmission electron microscopy (TEM) have been severely limited by the radiolysis and sputtering damage respectively undergone by the SEI and lithium-silicon alloys (Li x Si). In this work we demonstrate the possibility to map major SEI phases 2 as well as quantifying Li x Si compositions 3 and Si crystallinity from a single dataset by combining scanning transmission electron microscopy and low-loss electron energy loss spectroscopy 2 (STEM-EELS) 4 . The protocol we developed allows for large spectrum image acquisitions within short timeframes (~10 ms/voxel), making this method a robust and practical diagnostics tool for battery electrodes and other beam-sensitive nanostructured systems. Results on silicon nanoparticle (SiNP)-based electrodes shed light on the SEI’s deposition mechanism and morphological as well as chemical evolution along cycling (figure 1). Revealing the morphology of lithium fluoride (LiF) - large chunk-like deposits, lithium carbonates (such as Li2CO3) - thin conformal layers and carbon black allows us to get unprecedented insight into the SEI's formation mechanism at the particle scale, while mapping lithium content in Li-Si alloys shed light on the lithiation mechanisms at the particle and aggregate scale. Strong correlations between the SEI's local chemistry and our nanoparticles cycling performances were observed. Alloy formation appeared to make particles fuse together into what became a-Si/c-Si composite networks after delithiation (figure 2d), as revealed through careful examination of the EELS low-loss data. Furthermore, lithiation is shown to proceed in a very heterogeneous manner on the aggregate and particle scale, with particles at the aggregate/porosity boundary exhibiting higher lithium content (figure 2e), pristine and lithiation particles side to side (figure 2a), and composition gradients across single shells. Lithiation was also observed to proceed preferentially along grain boundaries (figure 2c), resulting in different behaviours between mono- and polycrystalline silicon powders, with polycristalline silicon showing higher lithium contents on average in charged electrodes. These tools were used to study the influence of the electrolyte solvent on the SEI's morphology and chemistry along cycling. Observations from electrodes cycled in pure carbonate electrolyte (1M LiPF6 in EC:DMC 1:1 + 10%FEC) at the 1st, 10th and 100th cycle were obtained and show clear trends in SEI accumulation and chemical evolution. These insights into both the SEI and the behavior of SiNPs are an exceptional asset in understanding the rapid capacity decay of silicon-based electrode. Reference s : [1] Delpuech, N.; Dupre, N.; Moreau, P.; Bridel, J.-S.; Lestriez, B.; Guyomard, D. ChemSusChem 2016. [2] Yakovlev, S.; Libera, M. Micron 2008, 39 (6), 734–740. [3] Danet, J.; Brousse, T.; Rasim, K.; Guyomard, D.; Moreau, P. Phys. Chem. 2010, 12 (1), 220–226. [4] Boniface, M., Quazuguel, Guyomard, D., Moreau, P., & Bayle-Guillemaud, P. (2016). Nano Letters. Figure 1

Elliptical Silicon Nanowire Covered by the SEI in a 2D Chemo-Mechanical Simulation

Tuning the Outward to Inward Swelling in Lithiated Silicon Nanotubes Via Surface Oxide Coating

Sandwich-Lithiation and Longitudinal Crack in Amorphous Silicon Coated on Carbon Nanofibers

Comparison of Different Elastic Strain Definitions for Largely Deformed SEI of Chemo-Mechanically Coupled Silicon Battery Particles

Silicon Nanowires as Anodes for Lithium-Ion Batteries: Full Cell Modeling

Modeling and Simulation of Chemo-Elasto-Plastically Coupled Battery Active Particles

Silicon Nanowires as Anodes for Lithium‐Ion Batteries: Full Cell Modeling

Voltage Hysteresis of Silicon Nanoparticles: Chemo-Mechanical Particle-SEI Model

Chemo-Mechanical Model of SEI Growth on Silicon Electrode Particles

Simulation of the Deformation for Cycling Chemo-Mechanically Coupled Battery Active Particles with Mechanical Constraints

Finite-Element Simulation for Ion Co-Intercalation Chemistry on Si Anode at Lithium-Ion Half-Cell

Single nanowire electrode electrochemistry of silicon anode by in situ atomic force microscopy: solid electrolyte interphase growth and mechanical properties

Failure Progression in the Solid Electrolyte Interphase (SEI) on Silicon Electrodes

Nanoscale Chemical Evolution of Silicon Negative Electrodes Characterized By Low-Loss STEM-Eels

Progressive growth of the solid–electrolyte interphase towards the Si anode interior causes capacity fading

Anisotropic Swelling and Fracture of Silicon Nanowires During Lithiation.

Electro-chemo-mechanical behavior of lithium-ion battery electrodes

A Chemo-Mechanical Model for Fully-Coupled Lithiation Reaction and Stress Generation in Viscoplastic Lithiated Silicon

Phase Field Damage Framework for Modeling Thin-Film Silicon Anodes in All-Solid-State Batteries

Evolution of solid electrolyte interphase and active material in the silicon wafer model system

A coupled mechanical-electrochemical phase-field formulation for understanding the evolution of lithiated-silicon sponge