Abstract:A continuous-flow isotope-ratio mass spectrometer (CF-IRMS, custom-made GasBenchII and Delta(plus)Advantage, ThermoFinnigan) was installed on a grassland site and interfaced with a closed-path infrared gas analyser (IRGA). The CF-IRMS and IRGA were housed in an air-conditioned travel van. Air was sampled at 1.5 m above the 0.07-m tall grassland canopy, drawn through a 17-m long PTFE tube at a rate of 0.25 L s(-1), and fed to the IRGA and CF-IRMS in series. The IRMS was interfaced with the IRGA via a stainless steel capillary inserted 0.5 m into the sample air outlet tube of the IRGA (forming an open split), a gas-tight pump, and a sample loop attached to the eight-port Valco valve of the continuous-flow interface. Air was pumped through the 0.25-mL sample loop at 10 mL s(-1) (a flushing frequency of 40 Hz). Air samples were analysed at intervals of approx. 2.8 min. Whole system precision was tested in the field using air mixed from pure CO2 and CO2-free air by means of mass flow controllers. The standard deviation of repeated single measurements was 0.21-0.07 per thousand for delta13C and 0.34-0.14 per thousand for delta18O of CO2 in air with mixing ratios ranging between 200-800 micromol mol(-1). The CO2 peak area measured by the IRMS was proportional to the CO2 mixing ratio (r2 = 1.00), allowing estimation of sample air CO2 mixing ratio from IRMS data. A 1-day long measurement cycle of CO2, delta13C and delta18O of air sampled above the grassland canopy was used to test the system for Keeling plot applications. Delta18O exhibited a clear diurnal cycle (4 per thousand range), but short-term (1-h interval) variability was small (average SD 0.38 per thousand). Yet, the correlation between delta18O and CO2 mixing ratio was relatively weak, and this was true for both the whole data set and 1-h subsets. Conversely, the delta13C of all 541 samples measured during the 25.2-h interval fitted well the Keeling regression (r2 = 0.99), yielding an intercept of -27.40 per thousand (+/-0.07 per thousand SE). Useful Keeling regressions (r2 > 0.9, average r2 = 0.96) also resulted from data collected over 1-h intervals of the 12-h long twilight and dark period. These indicated that 13C content of ecosystem respiration was approx. constant near -27.6 per thousand. The precision of the present system is similar to that of current techniques used in ecosystem studies which employ flask sampling and a laboratory-based CF-IRMS. Sampling (and measurement) frequency is greatly increased relative to systems based on flask sampling, and sampling time (0.025 s per sample) is decreased. These features increase the probability for sampling the entire CO2 range which occurs in a given time window. The system obviates sample storage problems, greatly minimises handling needs, and allows extended campaigns of high frequency sampling and analysis with minimal attendance.

A Hardened CO$_2$ Sensor for In-Ground Continuous Measurement in a Perennial Grass System

A Sensor Probe with Active and Passive Humidity Management for In Situ Soil CO2 Monitoring

Integrated Probe System for Measuring Soil Carbon Dioxide Concentrations

Single-Frequency Impedance Studies on an Ionic Liquid-Based Miniaturized Electrochemical Sensor Toward Continuous Low-Temperature CO2 Monitoring

[Open-path online monitoring of ambient atmospheric CO2 based on laser absorption spectrum]

eGreenhouse: Robotically positioned, low-cost, open-source CO2 analyzer and sensor device for greenhouse applications

Sensor array for wireless remote monitoring of carbon dioxide and methane near carbon sequestration and oil recovery sites

Development of an atmospheric CO2 sensor based on TDLAS-WMS

Design and optimization of wireless in‐situ sensor coupled with gas–water equilibrators for continuous pCO2 measurement in aquatic environments

A field system for measuring plant and soil carbon fluxes using stable isotope methods

Self-Calibrated Multiharmonic CO 2 Sensor Using VCSEL for Urban in Situ Measurement

Mobile, outdoor continuous-flow isotope-ratio mass spectrometer system for automated high-frequency 13C- and 18O-CO2 analysis for Keeling plot applications

High quality, continuous measurements of CO2 in Biosphere 2 to assess whole mesocosm carbon cycling

Investigating temperature and moisture profiles of seasonally frozen soil under different land covers using actively heated fiber Bragg grating sensors

Investigating soil temperature and moisture profiles under different land covers using actively heated fiber Bragg grating sensors

Integrated near-infrared QEPAS sensor based on a 28 kHz quartz tuning fork for online monitoring of CO2 in the greenhouse

A Novel Solid State Non-Dispersive Infrared CO2 Gas Sensor Compatible with Wireless and Portable Deployment

A Novel Technique for Monitoring Carbonate and Scale Precipitation Using a Batch-Process-Based Hetero-Core Fiber Optic Sensor

A CO2 Concentration Gradient Facility for Testing CO2 Enrichment and Soil Effects on Grassland Ecosystem Function

Assessing Soil Co2 Efflux Using Continuous Measurements of Co2 Profiles in Soils with Small Solid-State Sensors

Highly efficient colorimetric CO2 sensors for monitoring CO2 leakage from carbon capture and storage sites