Tunable topological edge modes in Su-Schrieffer-Heeger arrays

G. J. Chaplain,A. S. Gliozzi,B. Davies,D. Urban,E. Descrovi,F. Bosia,R. V. Craster

DOI: https://doi.org/10.1063/5.0152172

2024-08-19

Abstract:A potential weakness of topological waveguides is that they act on a fixed narrow band of frequencies. However, by 3D printing samples from a photo-responsive polymer, we can obtain a device whose operating frequency can be fine-tuned dynamically using laser excitation. This greatly enhances existing static tunability strategies, typically based on modifying the geometry. We use a version of the classical Su-Schrieffer-Heeger model to demonstrate our approach.

Applied Physics,Optics

What problem does this paper attempt to address?

The problem this paper attempts to address is: **How to dynamically adjust the operating frequency of topological edge modes**.

### Background and Problem
A potential weakness of topological waveguides is that they typically operate only within a fixed narrow frequency band. This means that if the operating frequency of the waveguide needs to be adjusted to suit different application scenarios, existing methods often require changing the geometric structure, which is usually static and not flexible enough. To overcome this limitation, the authors propose a method based on photoresponsive materials, which dynamically adjusts the operating frequency of topological edge modes by locally changing the mechanical parameters of the material through laser excitation.

### Solution
1. **Choosing the appropriate geometric structure**:
- The authors used the classic Su-Schrieffer-Heeger (SSH) model, adjusting the rod spacing at the interface to tune the characteristic frequency of the topological edge modes.
- This method has been theoretically studied in both 1D and 3D models, demonstrating that changing the rod spacing can move the characteristic frequency of the topological edge modes to different positions within the bandgap.

2. **Dynamic adjustment mechanism**:
- The authors used photoresponsive polymers (such as materials containing azobenzene dyes), which undergo molecular conformation changes under laser irradiation, leading to changes in the material's Young's modulus.
- By adjusting the laser power, the characteristic frequency of the topological edge modes can be dynamically tuned without changing the geometric structure.

### Experimental Verification
- **Experimental design**:
- 3D printed samples were prepared using commercial elastic resin mixed with dispersed azo dye.
- The experimental setup included a piezoelectric transducer and a laser tuning system, which changed the Young's modulus of the central region of the sample through laser irradiation.
- A laser vibrometer was used to measure the vibration velocity amplitude at different positions of the sample, verifying the existence of topological edge modes and their frequency changes.

- **Experimental results**:
- The experimental results showed that laser irradiation could significantly reduce the Young's modulus of the material, thereby lowering the characteristic frequency of the topological edge modes from about 9.5 kHz to a lower frequency, with a maximum change of approximately 300 Hz.
- This frequency change is reversible; when the laser power is removed or reduced, the characteristic frequency returns to its original value.

### Conclusion
The paper experimentally verifies the feasibility of dynamically adjusting the operating frequency of topological edge modes using photoresponsive materials. This method not only enhances the flexibility of existing geometric adjustment strategies but also provides new ideas for the dynamic adjustment of multidimensional topological systems. By offering a method to dynamically change the operating frequency, it greatly increases the versatility and application potential of these devices.