Abstract:Signal to noise ratios (SNR) in magnetic resonance microscopy images are limited by acquisition times and the decreasing number of spins in smaller voxels. Significant SNR gains from cooling of the RF receiver are only realized when the Johnson noise generated within the RF hardware is large compared to the electromagnetic noise produced by the sample. Cryogenic cooling of imaging probes is common in high field systems but proves difficult to insulate the sample from extreme temperatures. We designed a chamber to cool only the tune and match circuitry to show it is possible to achieve much of the available SNR gain available for cooled coils. We designed a microcoil circuit to resonate at 650 MHz for imaging on a 15.2 T scanner. Surface loops and solenoids of varying diameters were tested to determine the largest diameter coil that demonstrated significant SNR gains from cooling. A liquid N2 cryochamber was designed to cool the circuitry while leaving the RF coil in ambient air. As the cryochamber was filled with liquid N2, Q-factors were measured on the bench while monitoring the coil's surface temperature. Improvements of SNR on images of solutions were demonstrated via cooling the tune and match circuit in the magnet bore. At 650 MHz, loops and solenoids < 3 mm in diameter showed significant improvements in quality factor on the bench. The resistance of the variable capacitors and the coaxial cable were measured to be 45% and 32% of room temperature values near the Larmor frequency. Images obtained with a 2 turn, 3 mm diameter loop with the matching circuit at room temperature and then cooled with liquid nitrogen demonstrated SNR improvements of a factor of 2. By cooling the tune and match circuit and leaving the surface loop in ambient air, SNR was improved by a factor of 2. The results are significant because it allows for more space to insulate the sample from extreme temperatures.

Overcoming the Thermal-Noise Limit of Microwave Measurements by Pre-cooling with an Active Cold Load

Beating thermal noise in a dynamic signal measurement by a nanofabricated cavity optomechanical sensor

Bench-Top Cooling of a Microwave Mode Using an Optically Pumped Spin Refrigerator

On-chip Thermometry for Microwave Optomechanics Implemented in a Nuclear Demagnetization Cryostat

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T

Noise-suppressing and Lock-Free Optical Interferometer for Cold Atom Experiments

Near-ground state cooling in electromechanics using measurement-based feedback and Josephson parametric amplifier

Steady-state microwave mode cooling with a diamond NV ensemble

Cooling a nanomechanical resonator with quantum back-action

Cryogenic sensor enabling broad-band and traceable power measurements

Insertable system for fast turnaround time microwave experiments in a dilution refrigerator

Optomechanical Ground-State Cooling in a Continuous and Efficient Electro-Optic Transducer

Radiative Cooling of a Superconducting Resonator.

Microwave Loss Reduction in Cryogenically Cooled Conductors

Optomechanically Induced Transparency/Absorption in a 3D Microwave Cavity Architecture at Ambient Temperature

Enhancing the Resonance Stability of a High-Q Micro/nanoresonator by an Optical Means

Engineering the microwave to infrared noise photon flux for superconducting quantum systems

Radiatively cooled quantum microwave amplifiers

Dynamic acoustic optimization of pulse tube refrigerators for rapid cooldown

Significant noise improvement in a Kinetic Inductance Phonon-Mediated detector by use of a wideband parametric amplifier