Abstract:In this letter, we investigate the channel estimation problem for MIMO wireless communication systems with movable antennas (MAs) at both the transmitter (Tx) and receiver (Rx). To achieve high channel estimation accuracy with low pilot training overhead, we propose a tensor decomposition-based method for estimating the parameters of multi-path channel components, including their azimuth and elevation angles, as well as complex gain coefficients, thereby reconstructing the wireless channel between any pair of Tx and Rx MA positions in the Tx and Rx regions. First, we introduce a two-stage Tx-Rx successive antenna movement pattern for pilot training, such that the received pilot signals in both stages can be expressed as a third-order tensor. Then, we obtain the factor matrices of the tensor via the canonical polyadic decomposition, and thereby estimate the angle/gain parameters for enabling the channel reconstruction between arbitrary Tx/Rx MA positions. In addition, we analyze the uniqueness condition of the tensor decomposition, which ensures the complete channel reconstruction between the whole Tx and Rx regions based on the channel measurements at only a finite number of Tx/Rx MA positions. Finally, simulation results are presented to evaluate the proposed tensor decomposition-based method as compared to existing methods, in terms of channel estimation accuracy and pilot overhead.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is how to perform channel estimation efficiently and accurately in a multiple - input multiple - output (MIMO) wireless communication system with movable antennas (MAs). Specifically, the paper focuses on how to estimate the parameters of multipath channel components, including their azimuth angles, elevation angles, and complex gain coefficients, through the tensor decomposition method when both the transmitter (Tx) and the receiver (Rx) are equipped with movable antennas, so as to reconstruct the wireless channel between any pair of Tx and Rx MA positions.
### Main Challenges
1. **Limitations of Traditional MIMO Systems**: Traditional MIMO systems cannot fully utilize the spatial variation/degrees of freedom of the wireless channel due to the fixed geometry of the antenna array, even in large - scale MIMO systems.
2. **Complexity of Channel Estimation**: In order to optimize the position of the MA, it is necessary to obtain all channel information between any pair of positions in the entire Tx/Rx antenna movement area, which is more complex than the channel estimation in traditional MIMO systems.
3. **Deficiencies of Existing Methods**: Existing compressed sensing (CS) methods rely on discrete - angle quantization, which limits the accuracy of channel estimation, and the problem of channel reconstruction in MIMO systems with multiple MAs has not been effectively solved yet.
### Solutions
To solve the above problems, the paper proposes a channel estimation/reconstruction method based on tensor decomposition. The main steps of this method are as follows:
1. **Two - stage Antenna Movement Pattern**:
- First stage: The transmitter - end antennas send pilot signals at different positions, while the receiver - end antennas remain at an initial position.
- Second stage: The receiver - end antennas receive pilot signals at different positions, while the transmitter - end antennas remain at an initial position.
2. **Tensor Representation and Decomposition**:
- Represent the received pilot signals as a third - order tensor.
- Obtain factor matrices through the canonical polyadic decomposition (CPD) of the tensor, and then estimate the parameters of the multipath channel components.
3. **Channel Reconstruction**:
- Use the estimated factor matrices to extract the azimuth angle, elevation angle, and complex gain coefficient.
- Based on these parameters, reconstruct the wireless channel between any pair of Tx and Rx MA positions.
### Uniqueness Analysis
The paper also analyzes the uniqueness conditions of tensor decomposition to ensure that complete channel reconstruction of the entire Tx and Rx areas can be achieved by performing channel measurements only at a limited number of Tx/Rx MA positions.
### Simulation Results
The simulation results show that the proposed tensor - decomposition - based method is superior to existing methods in terms of channel estimation accuracy and pilot overhead, especially under high signal - to - noise ratio (SNR) conditions, with a significant performance improvement.
Through this method, the paper successfully solves the problem of efficient and accurate channel estimation in MIMO systems with movable antennas, significantly reducing the pilot training overhead.