Generalized Averaging Method for Power Electronics Modeling from DC to above Half the Switching Frequency

Hongchang Li,Kangping Wang,Jingyang Fang,Wenjie Chen,Xu Yang

2024-06-27

Abstract:Modeling power electronic converters at frequencies close to or above half the switching frequency has been difficult due to the time-variant and discontinuous switching actions. This paper uses the properties of moving Fourier coefficients to develop the generalized averaging method, breaking though the limit of half the switching frequency. The paper also proposes the generalized average model for various switching signals, including pulse-width modulation (PWM), phase-shift modulation, pulse-frequency modulation (PFM), and state-dependent switching signals, so that circuits and modulators/controllers can be modeled separately and combined flexibly. Using the Laplace transform of moving Fourier coefficients, the coupling of signals and their sidebands at different frequencies is clearly described as the coupling of moving Fourier coefficients at the same frequency in a linear time-invariant system framework. The modeling method is applied to a PWM controlled boost converter, a V2 constant on-time controlled buck converter, and a PFM controlled LLC converter, for demonstration and validation. Experimental results of the converters in different operating modes show that the proposed models have higher accuracy than exiting models, especially in the frequency range close to or above half the switching frequency. The developed method can be applied to almost all types of power electronic converters.

Systems and Control

What problem does this paper attempt to address?

The paper attempts to address the difficulty of modeling power electronic converters in the frequency range close to or above half of the switching frequency. Specifically:

1. **Time Variability and Discontinuity**: Due to the time variability and discontinuity of switching actions, traditional modeling methods often fail to accurately describe the dynamic behavior of the system in the high-frequency range (close to or above half of the switching frequency).

2. **Limitations of Existing Methods**:
- **State-Space Averaging Method**: Although widely used, its effective range is limited to frequencies well below half of the switching frequency.
- **Discrete Modeling and Sampled Data Modeling**: While performing well in the high-frequency range, they rely on complex switching time calculations and are inconvenient when combined with other system models in practical applications.
- **Describing Function Method**: Although it can handle high frequencies, it requires lengthy derivations in the case of periodic switching, and simplified assumptions may introduce errors.
- **Extended Describing Function (EDF) Method**: While simplifying the implementation of the describing function method, its effective range is still limited to below half of the switching frequency.
- **Multi-Frequency Models and Harmonic State-Space (HSS) Models**: Although effective in certain topologies, their application range is limited and they require complex closed-loop control models.

3. **Objective**: To develop a new generalized averaging method that can break through the half-switching frequency limit, accurately model different types of power electronic converters, and establish a more solid foundation for the time-frequency analysis of power electronic systems.

Through these improvements, the paper aims to provide a more accurate and general modeling method applicable to power electronic converters under various modulation and control schemes.