Abstract:Single-phase liquid-cooled heat sinks are a preferred mode of thermal management for many power dense electronic applications. This paper studies the design, optimization, and thermal-hydraulic performance of polymer manifolds directing coolant to the base plate of multi-chip power modules. Direct cooling eliminates the need for thermal interface materials which form a major bottleneck to junction-to-coolant thermal resistance reduction in state-of-the-art metallic cold plates. We use 2D topology optimization (TO) to develop designs using side view (SVTO) and top view (TVTO) sections of the flow domain in contact with the power module base plate. We also use 3D TO design (CTO) which combines SCTO and TVTO. The TO designs are compared against conventional mini-channel designs including rectangular, zig-zag and serpentine channels. Cooling performance of the different designs is computed using computational fluid dynamic (CFD) simulations. Experimental quantification is achieved through measurements of the silicon carbide device junction temperature and inter-device temperature difference along with the pressure drop influencing the pumping power requirement. The CFD simulations were used to identify optimized manifold designs which were fabricated using selective laser sintering of PA12 and validated experimentally using surrogate heaters. Zig-zag designs showed the best performance among the conventional designs (0.93 (cm 2 ·K)/W), at the cost of high pressure drop (> 2.4 kPa). Serpentine channel designs were effective in limiting inter-device temperature difference (< 0.260C) through multiple changes of flow direction. The TO designs improved the performance (1.1 (cm 2 ·K)/W) when compared against conventional channels showing lower maximum temperatures with lower pressure drops (0.8 kPa). Fluid manifolds are shown to greatly influence the coolant flow field, leading to flow maldistribution with low velocity pockets, emphasizing the need for optimizing the complete manifold design.

Topology optimization of contact-aided thermo-mechanical regulators

Topology optimization of self-contacting structures

Efficient topology optimization for geometrically nonlinear multi-material systems under design-dependent pressure loading

A Multi-Objective Topology Optimization Methodology and Its Application to Electromagnetic Actuator Designs

A Novel Derivative Free Methodology for Multi-Material Topology Optimization Based on Projective Transformations and Boolean Operations

Enhancing the cooling performance of thermocouples: a power-constrained topology optimization procedure

Temperature-Constrained Topology Optimization of Transient Heat Conduction Problems

Three-dimensional topology optimization of thermal-fluid-structural problems for cooling system design

Comprehensive polygonal topology optimization for triplet thermo-mechanical-pressure multi-material systems

Topology optimization of non-linear electromagnetic actuator based on Reluctance Network Analysis

Topology Optimization of Steady-state Heat Conduction Problems with Design-dependent Heat Loads

Topology optimization of heat sinks for instantaneous chip cooling using a transient pseudo-3D thermofluid model

Heat Dissipation Design Based On Topology Optimization And Auxiliary Materials

Topology Optimization to Minimize the Dynamic Compliance of a Bi-Material Plate in a Thermal Environment

Topology Optimization of Planar Heat Sinks Considering Out-of-plane Design-Dependent Deformation Problems

Topology Optimization of Turbulent Flow Cooling Structures Based on the k-ε Model

Topology optimization for transient thermoelastic structures under time-dependent loads

Topological Design Optimization Approach for Winding Oil Flow Paths in Oil-Natural Air-Natural Transformers Based on a Fluidic-Thermal Coupled Model

Topology Optimization of Channel Cooling Structures Considering Thermomechanical Behavior

Thermal-fluid Topology Optimization with Unconditional Energy Stability and Second-Order Accuracy Via Phase-Field Model

Conventional and topologically optimized polymer manifolds for direct cooling of power electronics