Abstract:The impact of a plunging breaker on a partially submerged cube is explored experimentally in a wave tank equipped with a programable wave maker. The experiments are conducted with the cube (dimension $L=30.48$ cm) positioned at one streamwise location relative to the wave maker and at three heights relative to the undisturbed water level. A single, repeatable wave maker motion producing a breaker with a nominal wavelength of 1.18 m is used. The water surface profile at the stream wise vertical center plane of the cube is measured with a cinematic Laser-Induced Fluorescence technique and the impact pressures on the front face of the cube are measured with piezoelectric dynamic pressure transducers. The surface profile measurements and the impact pressure measurements are synchronized. When the cube is positioned vertically so that its bottom face is at either $0.5L$ or $0.25L$ below the undisturbed water surface, the water surface profile behaviors are basically similar with a nearly circular arc forming between the water contact point on the front face of the cube and the wave crest. As the impact proceeds, this arc shrinks to zero size and creates a fast-moving vertical jet in a manner similar to that found in previous studies of wave impact on bottom-mounted vertical walls. In the case where the cube is one quarter submerged, a small jet also forms at the crest and impacts the front face of the cube just before the circular arc reaches zero size. When the bottom of the cube is located at the undisturbed water level the wave impact is dramatically different. In this case, it appears that a packet of air is entrapped during the impact and the surface pressure subsequently oscillates with a frequency of about 2,000 Hz.

Cracking of submerged beds

Centrifuge Modelling of Blast Effects in Dry Sand: Coriolis Effect and Soil Arching

Drop impact on wet granular beds: water-content effects on the cratering

Craters Formed in Granular Beds by Impinging Jets of Gas

Dynamics of crater formations in immersed granular materials

On the mechanics of droplet surface crater during impact on immiscible viscous liquid pool

Air jet impact craters on granular surfaces: a universal scaling

Investigating projectile penetration into immersed granular beds via CFD-DEM coupling

Dropping the Ball: The effect of anisotropic granular materials on ejecta and impact crater shape

Experimental Model of Pockmarks from Gas Hydrate Decomposition by Aeration

Centrifuge modeling and analysis of submarine landslides triggered by elevated pore pressure

Microfluidic jet impacts on deep pools transition from capillary-dominated cavity closure to gas pressure-dominated closure at higher Weber numbers

Controlled and impulsive compression of an entrapped air bubble during impact

The role of interstitial gas in determining the impact response of granular beds

The Impact of a Deep-Water Plunging Breaker on a Partially Submerged Cube

Air-cushioning effect and Kelvin-Helmholtz instability before the slamming of a disk on water

Air-cushioning below an impacting wave-structured disk: Free-surface deformation and slamming load

Penetration of jet piles on submerged granular beds

Hydrogel sphere impact cratering, spreading and bouncing on granular media

Gas density influences the transition from capillary collapse to surface seal in microfluidic jet impacts on deep pools

Breaking of a floating particle raft by water waves