An Improved Design for All-Photonic Quantum Repeaters

Ashlesha Patil,Saikat Guha

2024-05-20

Abstract:All-photonic quantum repeaters use multi-qubit photonic graph states, called repeater graph states (RGS), instead of matter-based quantum memories, for protection against predominantly loss errors. The RGS comprises tree-graph-encoded logical qubits for error correction at the repeaters and physical {\em link} qubits to create entanglement between neighboring repeaters. The two methods to generate the RGS are probabilistic stitching -- using linear optical Bell state measurements (fusion) -- of small entangled states prepared via multiplexed-probabilistic linear optical circuits fed with single photons, and a direct deterministic preparation using a small number of quantum-logic-capable solid-state emitters. The resource overhead due to fusions and the circuit depth of the quantum emitter system both increase with the size of the RGS. Therefore engineering a resource-efficient RGS is crucial. We propose a new RGS design, which achieves a higher entanglement rate for all-photonic quantum repeaters using fewer qubits than the previously known RGS would. We accomplish this by boosting the probability of entangling neighboring repeaters with tree-encoded link qubits. We also propose a new adaptive scheme to perform logical BSM on the link qubits for loss-only errors. The adaptive BSM outperforms the previous schemes for logical BSM on tree codes when the qubit loss probability is uniform. It reduces the number of optical modes required to perform logical BSM on link qubits to improve the entanglement rate further.

Quantum Physics

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to increase the entanglement generation rate of all - photonic quantum repeaters while reducing resource consumption. Specifically, the author proposes the following improvement measures:

1. **Design a more efficient Repeater Graph State (RGS) for reuse**:
- Traditional RGS uses a clique, while this paper proposes to use a biclique. This change reduces the number of edges in the RGS, thereby reducing resource requirements.
- The core structure of the biclique makes the qubits in each partition connected to all the qubits in the other partition, which improves resource efficiency while maintaining the protocol rate.

2. **Encode Link Qubits to enhance fault - tolerance**:
- In addition to the inner qubits, tree - code encoding is also performed on the Link Qubits to protect them from being affected by dissipation.
- This encoding method increases the success probability of Link Bell - State Measurements (BSM), thereby increasing the overall entanglement generation rate.

3. **Propose a new adaptive - logic BSM scheme**:
- The author designs a new adaptive - logic BSM scheme, which combines linear - optical fusion and single - qubit measurements.
- This scheme performs well in both low - loss and high - loss situations, and especially in high - loss situations, its performance is better than existing static and dynamic BSM schemes.

Through these improvements, the paper aims to improve the performance of all - photonic quantum repeaters in pure - loss channels, enabling them to exceed the entanglement generation rate of direct - transmission protocols and show higher efficiency and reliability in long - distance communication.