Abstract:The forthcoming sixth-generation (6G) industrial Internet-of-Things (IIoT) subnetworks are expected to support ultra-fast control communication cycles for numerous IoT devices. However, meeting the stringent requirements for low latency and high reliability poses significant challenges, particularly due to signal fading and physical obstructions. In this paper, we propose novel time division multiple access (TDMA) and frequency division multiple access (FDMA) communication protocols for cooperative transmission in IIoT subnetworks. These protocols leverage secondary access points (sAPs) as Decode-and-Forward (DF) and Amplify-and-Forward (AF) relays, enabling shorter cycle times while minimizing overall transmit power. A classification mechanism determines whether the highest-gain link for each IoT device is a single-hop or two-hop connection, and selects the corresponding sAP. We then formulate the problem of minimizing transmit power for DF/AF relaying while adhering to the delay and maximum power constraints. In the FDMA case, an additional constraint is introduced for bandwidth allocation to IoT devices during the first and second phases of cooperative transmission. To tackle the nonconvex problem, we employ the sequential parametric convex approximation (SPCA) method. We extend our analysis to a system model with reconfigurable intelligent surfaces (RISs), enabling transmission through direct and RIS-assisted channels, and optimizing for a multi-RIS scenario for comparative analysis. Simulation results show that our cooperative communication approach reduces the emitted power by up to 7.5 dB while maintaining an outage probability and a resource overflow rate below $10^{-6}$. While the RIS-based solution achieves greater power savings, the relay-based protocol outperforms RIS in terms of outage probability.

Control-Aware Transmit Power Allocation for 6G In-Factory Subnetwork Control Systems

A novel method for improving the power response of a single-controllable VSG-based active distribution network

Power Control for 6G Industrial Wireless Subnetworks: A Graph Neural Network Approach

Distributed Real-Time Multi-Objective Control of a Virtual Power Plant in DC Distribution Systems

Control-Aware Transmission Scheduling for Industrial Network Systems Over a Shared Communication Medium

Slow Admission and Power Control for Small Cell Networks Via Distributed Optimization

Co-design of Optimal Transmission Power and Controller for Networked Control Systems Under State-dependent Markovian Channels

Analysis and Optimization of Power Control in Multiuser Cognitive Wireless Networks

Tradeoff Between Network Energy Consumption and Terminal Energy Consumption Via Small Cell Power Control

A Learning Approach for Joint Design of Event-triggered Control and Power-Efficient Resource Allocation

Transmission Power Control for Remote State Estimation in Industrial Wireless Sensor Networks

Power Efficient Cooperative Communication within IIoT Subnetworks: Relay or RIS?

Transmit power policies for stochastic stabilisation of multi-link wireless networked control systems

Optimal Downlink-Uplink Scheduling of Wireless Networked Control for Industrial IoT

Co-design of Safe and Efficient Networked Control Systems in Factory Automation with State-dependent Wireless Fading Channels

Robust Power Control in Cognitive Radio Networks: A Distributed Way

Distributed Stochastic Power Control in Ad-hoc Networks: A Nonconvex Case

Collaborative Sub-Channel Allocation with Power Control in Small Cell Networks

Uplink Power Control in Integrated Access and Backhaul Networks

An efficient genetic algorithm for large-scale transmit power control of dense industrial wireless networks

Semi-dynamic Green Resource Management in Downlink Heterogeneous Networks by Group Sparse Power Control