Abstract:To examine the environmental characteristics of the microgravity force and the weathered layer on an asteroid surface, a symmetric wheel brush asteroid sampler is proposed for the collection of particles on the asteroid surface. To study the influence of the wheel brush rotation speed on the sampling efficiency and the driving torque required for the wheel brush, the contact dynamics model between particles and sampling wheel brushes is established and a simulation and experimental verification of the sampling process are conducted. The parameter calibration of the sampled particles is studied first, and the calibrated particle parameters are used in the numerical simulation of the sampling process. The sampling results and the particle stream curves are obtained for the working conditions of different rotation speeds, and the effects of different parameter settings on the sampling efficiency are analyzed. In addition, a set of rotating symmetrical sampling wheel brush devices is built for the ground test, and the dynamic torque sensor is used to test the torque change of the wheel brush during the sampling process. The relationship between the speed of the wheel brush and the driving torque of the wheel brush motor is determined by comparing the simulation results with the test results. Results indicate that when the rotating speed of the wheel brush is faster, the sampling efficiency is higher, and the driving torque required for the sampling wheel brush is greater. Moreover, a numerical simulation analysis of the sampling process of the wheel brush sampler in a microgravity environment is conducted to determine the optimal speed condition, and the brushing test of the wheel brush sampler in the microgravity environment is verified with the drop tower method. This research proposes the structural optimization design and motor selection of a wheel brush asteroid sampler, which provides important reference value and engineering significance.

Dynamic Three-dimensional Simulation of Surface Charging on Rotating Asteroids

Three-dimensional Simulation of Surface Charging in Meteorite Craters on Rotating Asteroids

Three-dimensional Particle-in-cell Simulations of the Solar Wind Interaction with Asteroid 2016 HO 3

The Dynamical Environments Analysis of Surface Particles for Different Shaped Asteroids

DYNAMICAL SUBSTITUTES OF EQUILIBRIUM POINTS OF ASTEROIDS UNDER SOLAR RADIATION PRESSURE

Numerical simulation and experimental research on the wheel brush sampling process of an asteroid sampler

Surface dynamics of small fast-rotating asteroids: Analysis of possible regolith on asteroid 2016 HO3

The common trend of saltation particles on the surface of fast-rotating asteroids

The Cumulation of Debris Clouds around a Fast-rotating Asteroid

Dynamical Behavior of Flexible Net Spacecraft for Landing on Asteroid

Improved Simulation of the Mass Charging for ASTROD I

Deep operator neural network applied to efficient computation of asteroid surface temperature and the Yarkovsky effect

Simulation of dust grain charging under hypervelocity impact plasma environment

Numerical Simulation of the Lunar Polar Environment: Implications for Rover Exploration Challenge

Simulation and Analysis of Asteroid Force Closure Anchoring Performance Based on Discrete Element Method

Orbital Analysis of a Dual Asteroid System Explorer Based on the Finite Element Method

Forced Periodic Motions by Solar Radiation Pressure Around Uniformly Rotating Asteroids

Fast Solution Continuation of Time-Optimal Asteroid Landing Trajectories Using Deep Neural Networks

Error Analysis for Rotating-drift-scan Charge-coupled Device Observation of Near-Earth Asteroids

Modeling Binary Asteroids: Integrating Orbital and Rotational Motion for Physical Property Inversion