What problem does this paper attempt to address?

This paper aims to solve the problem of suppressing spontaneous emission in superconducting qubits in order to achieve fast dispersive measurement and reset without sacrificing qubit lifetime. Specifically, the paper proposes a method to suppress the qubit mode from decaying into the read - out resonator through the feedline by means of destructive interference. This method, called "interferometric Purcell filter", does not require dedicated filtering components or impedance mismatches in the feedline and is suitable for applications such as all - pass read - out. The authors designed and fabricated a device using this scheme and demonstrated resonator - mediated attenuation suppression effects of more than two orders of magnitude within a 400 - MHz bandwidth. ### Background and Problem Description of the Paper Superconducting qubits are a strong candidate platform for quantum computing because of their high tunability. By dispersively coupling qubits to read - out resonators, quantum non - destructive measurements can be performed. The qubit will shift the resonator frequency according to its state, which can be measured by a microwave read - out signal, thereby determining the qubit state. Fast measurement and reset are crucial for applications such as quantum error correction to minimize qubit decoherence and increase the repetition rate of the code. However, in order to extract qubit state information as quickly as possible during the read - out process, read - out resonators with large bandwidths or high attenuation rates are usually designed, which also increases the rate at which qubits lose information to the environment through Purcell attenuation. To solve this trade - off problem, the Purcell filter was introduced, which achieves low admittance at high frequencies by engineering the admittance of the resonator at the qubit frequency. ### Solution The solution proposed in this paper is to suppress the emission of the qubit mode into the feedline by means of destructive interference by coupling at two different points between the read - out resonator and the feedline. This "interferometric Purcell filter" does not require additional filtering components or impedance mismatches in the feedline and is suitable for application scenarios such as all - pass read - out. The authors demonstrated resonator - mediated attenuation suppression effects of more than two orders of magnitude within a 400 - MHz bandwidth by designing and fabricating an experimental device. ### Experimental Results The experimental results show that at the target qubit frequency, the maximum destructive interference can be achieved by optimizing the ratio of mutual inductance to mutual capacitance \( r=\frac{L_m}{C_m} \). Under the optimal ratio \( r_{\text{opt}} \), a sharp band - stop response centered at the target qubit frequency was experimentally observed, and the unfiltered Purcell attenuation rate was significantly reduced. When the qubit is at the band - stop frequency, the measured Purcell - limited lifetime exceeds 16 milliseconds, the corresponding Purcell attenuation rate is less than 10 Hz, and the Purcell suppression factor exceeds 2,000. ### Conclusions and Prospects In conclusion, this paper successfully suppresses the Purcell attenuation of qubits through destructive interference. The proposed interferometric Purcell filter does not require dedicated filtering components or impedance mismatches in the feedline and is suitable for applications such as all - pass read - out. The principle of this method has wide applicability and can be extended to transmission - line resonators of other lengths and other combinations of coupling methods. Future work will further optimize the device layout, reduce the footprint, and explore more application scenarios.

Interferometric Purcell suppression of spontaneous emission in a superconducting qubit

Fast multiplexed superconducting qubit readout with intrinsic Purcell filtering

Photon-noise-tolerant dispersive readout of a superconducting qubit using a nonlinear Purcell filter

High-suppression-ratio and wide bandwidth four-stage Purcell filter for multiplexed superconducting qubit readout

Saturable Purcell filter for circuit quantum electrodynamics

Directional emission of a readout resonator for qubit measurement

Enhancing Dispersive Readout of Superconducting Qubits Through Dynamic Control of the Dispersive Shift: Experiment and Theory

Characterization of broadband Purcell filters with compact footprint for fast multiplexed superconducting qubit readout

Ultrafast superconducting qubit readout with the quarton coupler

Broadband Filters for Abatement of Spontaneous Emission in Circuit Quantum Electrodynamics

Broadband Bandpass Purcell Filter for Circuit Quantum Electrodynamics

Mechanical Purcell Filters for Microwave Quantum Machines

Improved Superconducting Qubit State Readout by Path Interference

Dispersive Qubit Readout with Intrinsic Resonator Reset

Fast high-fidelity quantum nondemolition readout of a superconducting qubit with tunable transverse couplings

Multiplexed Readout of Superconducting Qubits Using a 3D Re-entrant Cavity Filter

Superconducting-qubit readout via low-backaction electro-optic transduction

Dispersive measurements of superconducting qubit coherence with a fast, latching readout