Femtosecond laser written waveguides in sapphire for visible light delivery

Sarah Winkler,Joachim R. Krenn,Jakob Wahl,Alexander Zesar,Yves Colombe,Klemens Schüppert,Clemens Rössler,Christian Sommer,Philipp Hurdax,Philip Lichtenegger,Bernhard Lamprecht
2024-10-14
Abstract:A promising solution for scalable integrated optics of trapped-ion quantum processors are curved waveguides guiding visible light within sapphire bulk material. To the best of our knowledge, no curved waveguides were investigated in sapphire so far, and no measurements of waveguides with visible light in undoped planar sapphire substrates were reported. Here, we demonstrate femtosecond laser writing of depressed cladding waveguides in sapphire. Laser parameters, such as pulse energy, pulse duration, and repetition rate, as well as waveguide geometry parameters, were optimized to guide 728 nm light. This resulted in single-mode waveguides with a propagation loss of 1.9(3) dB/cm. The investigation of curved waveguides showed a sharp increase in total loss for curvature radii below 15 mm. Our results demonstrate the potential of femtosecond laser writing as a powerful technique for creating integrated optical waveguides in the volume of sapphire substrates. Such waveguides could be a building block for integrated optics in trapped-ion quantum processors.
Optics,Quantum Physics
What problem does this paper attempt to address?
### Problems the paper attempts to solve This paper aims to solve the key problems of realizing scalable integrated optical devices in sapphire materials, especially the curved waveguides for ion - trap quantum processors. Specifically, the goals of the paper are as follows: 1. **Realize curved waveguides for visible - light transmission**: - The authors point out that there are currently no studies on curved waveguides in sapphire, nor are there any measurement reports on visible - light waveguides in undoped planar sapphire substrates. - They attempt to fabricate Depressed Cladding Waveguides (DCWs) that can guide visible light (728 nm) in sapphire by femtosecond laser direct - writing technology. 2. **Optimize waveguide geometric parameters and laser parameters**: - In order to achieve single - mode transmission and minimize propagation losses, the authors optimize the geometric parameters of the waveguide (such as the number of lines, diameter, etc.) and laser parameters (such as pulse energy, pulse duration, repetition rate, etc.). - Through these optimizations, they successfully prepared single - mode waveguides with a propagation loss of 1.9(3) dB/cm. 3. **Study the performance of curved waveguides**: - The authors studied the influence of different curvature radii on the total waveguide loss. The results show that when the curvature radius is less than 15 mm, the total loss increases sharply. - These results indicate the potential of femtosecond laser direct - writing technology in creating integrated optical waveguides in sapphire, especially for applications in ion - trap quantum processors. ### Summary The main goal of the paper is to fabricate curved waveguides that can guide visible light in sapphire by femtosecond laser direct - writing technology and optimize their geometric and laser parameters to achieve low - loss single - mode transmission. This research provides important technical support for realizing scalable integrated optical devices in ion - trap quantum processors.