Sequence Dependence of Critical Properties for 2-letter Chains

Athanassios Z. Panagiotopoulos

2024-05-14

Abstract:Histogram-reweighting grand canonical Monte Carlo simulations are used to obtain the critical properties of lattice chains composed of solvophilic and solvophobic monomers. The model is a modification of one proposed by Larson \emph{et al.} [J. Chem. Phys. 83, 2411 (1985)], lowering the ``contrast'' between beads of different type to prevent aggregation into finite-size micelles that would mask true phase separation between bulk high- and low-density phases. Oligomeric chains of length between 5 and 24 beads are studied. Mixed-field finite-size scaling methods are used to obtain the critical properties with typical relative accuracies of better than $10^{-4}$ for the critical temperature and $10^{-3}$ for the critical volume fraction. Diblock chains are found to have lower critical temperatures and volume fractions relative to the corresponding homopolymers. Addition of solvophilic blocks of increasing length to a fixed-length solvophobic segment results in a decrease of both critical temperature and critical volume fraction, with an eventual slow asymptotic approach to the long-chain limiting behavior. Moving a single solvophobic or solvophilic bead along a chain leads to a minimum or maximum in the critical temperature, with no change in critical volume fraction. Chains of identical length and composition have a significant spread in their critical properties, depending on their precise sequence. The present study has implications on understanding biomolecular phase separation and for developing design rules for synthetic polymers with specific phase separation properties. It also provides data potentially useful for the further development of theoretical models for polymer and surfactant phase behavior.

Soft Condensed Matter

What problem does this paper attempt to address?

This paper aims to explore how the critical properties of short - chain polymers composed of two types of monomers, solvophilic and solvophobic, are affected by the sequence. Specifically, the study modifies the model proposed by Larson et al. to reduce the "contrast" between different types of beads in order to prevent the formation of finite - sized micelles, which would mask the true phase - separation phenomenon. The paper uses the grand - canonical Monte Carlo simulation method with histogram re - weighting to study oligomeric chains with lengths between 5 and 24 beads, obtains the critical properties of these chains, such as critical temperature and critical volume fraction, and analyzes how these properties change with chain length, block length, and monomer position.

The main research questions in the paper include:
1. **Chain - length dependence**: Study how the critical temperature and critical volume fraction of homopolymer chains of different lengths (from 5 to 24 beads) change. According to the Flory - Huggins theory, the inverse critical temperature \( \frac{1}{T_c} \) is expected to change according to the relationship of \( \frac{1}{\sqrt{r}}+\frac{1}{2r} \) as the chain length \( r \) increases.
2. **Block - length dependence of diblock chains**: For a diblock chain \( H_hT_{8 - h} \) with a fixed total length of 8 beads, study the effect of the length \( h \) of the solvophilic segment on the critical temperature and critical volume fraction. The results show that both the critical temperature and the critical volume fraction first decrease and then increase as \( h \) increases, reaching their minimum values at \( h = 5 \) and \( h = 3 \), respectively.
3. **Overall - length dependence when the end - segment length is fixed**: Study the critical properties of the diblock chain \( H_hT_5 \) with a fixed 5 - bead solvophobic end - segment and a variable - length solvophilic segment. The results indicate that as the length of the solvophilic segment increases, both the critical temperature and the critical volume fraction decrease significantly, but gradually stabilize in longer chains.
4. **Single - bead position dependence**: Study the effect of the position change of a "different" bead (i.e., a bead with properties opposite to those of the other beads in the chain) in an 8 - bead - long chain on the critical temperature. The results show that moving a solvophobic bead from one end of the chain to the middle will cause a slight decrease in the critical temperature, while moving a solvophilic bead from one end of the chain to the middle will cause a significant increase in the critical temperature.
5. **Overall - architecture effect**: Compare the effects of different arrangements of 4 solvophobic beads and 4 solvophilic beads in an 8 - bead - long chain on the critical properties. The results show that different arrangements lead to significant differences in the critical temperature and critical volume fraction, among which the diblock chain \( HHHHTTTT \) has the lowest critical volume fraction, and the triblock chain \( TTHHHHTT \) has the highest critical temperature.

Through these studies, the paper provides important insights into biomolecular phase separation and the design rules of synthetic polymers, and provides valuable data for the development of theoretical models.