Industrial Cabling in Constrained Environments: a Practical Approach and Current Challenges

Tanureza Jaya,Benjamin Michalak,Marcel Radke,Kevin Haninger

2024-04-17

Abstract:Cabling tasks (pulling, clipping, and plug insertion) are today mostly manual work, limiting the cost-effectiveness of electrification. Feasibility for the robotic grasping and insertion of plugs, as well as the manipulation of cables, have been shown in research settings. However, in many industrial tasks the complete process from picking, insertion, routing, and validation must be solved with one system. This often means the cable must be directly manipulated for routing, and the plug must be manipulated for insertion, often in cluttered environments with tight space constraints.

Robotics

What problem does this paper attempt to address?

This paper mainly discusses the problem of industrial wiring in constrained environments, which is currently a field that relies heavily on manual operation and is costly. Although previous research has demonstrated the feasibility of robots grasping and inserting plugs, in practical industrial tasks, a system is needed to complete the entire process of picking up, inserting, routing, and verifying, often requiring direct manipulation of cables and plugs, which is particularly complex in confined spaces.

The paper presents a comprehensive analysis of industrial wiring tasks and proposes a solution that includes the entire process of grasping, plug insertion, fixation, and final insertion. The authors summarize industrial requirements, consider space limitations, tolerances, and possible methods of integrating the wiring process into the production process. They design a gripper specifically for commonly used FASTON and cubic industrial connectors to ensure reliable grasping of plugs and pulling cable segments. They also propose a passive component for correcting the cable's position before insertion, allowing the robot to re-grasp the plug.

The proposed solution in the paper was demonstrated on industrial products with realistic space requirements and tolerances. It identifies the challenges faced by current wiring scenarios and proposes potential improvements to enhance automation-friendliness. The research is funded by the European Union's Horizon 2020 Research and Innovation Programme.

The paper discusses the current technological state, including the steps of cable grasping, routing, and plug insertion, and highlights the challenges faced by existing methods in achieving full automation, such as connector design diversity, cable flexibility, and space limitations. Additionally, it introduces the design of grippers for FASTON and industrial connectors, as well as the insertion method, including how to assemble cables through position control while avoiding complex control methods.

In summary, this paper attempts to address how to achieve efficient and automated cable assembly in industrial environments, particularly in situations with limited space and strict tolerances.