Abstract:This paper proposes a gray-box stability analysis mechanism based on data-driven dynamic mode decomposition (DMD) for commercial grid-tied power electronics converters with limited information on its control parameters and topology. By fusing the underlying physical constraints of the state equations into data snapshots, the system dynamic state matrix and input matrix are simultaneously approximated to identify the dominant system dynamic modes and eigenvalues using the DMD with control (DMDc) algorithm. While retaining the advantages of eliminating the need for intrinsic controller information, the proposed gray-box method establishes higher accuracy and interpretable outcomes over the conventional DMD method. Finally, under experimental conditions of a low-frequency oscillation scenario in electrified railways featuring a single-phase converter, the proposed gray-box DMDc is verified to identify the dominant eigenvalues more accurately.

What problem does this paper attempt to address?

The paper primarily addresses the stability analysis issues faced by grid-tied power electronics converters by proposing a gray-box stability analysis mechanism. Specifically, the paper tackles the following key problems: 1. **Problems with existing methods**: Traditional model-based methods (such as small-signal impedance methods and eigenvalue analysis) require detailed controller information, which is often not accessible in commercial power electronics converters. While data-driven methods are suitable for black-box conditions, they usually lack interpretability. 2. **Limitations of Dynamic Mode Decomposition (DMD)**: DMD is a powerful data-driven method that can extract dynamic modes and eigenvalues from measurement data snapshots for system stability assessment. However, when only considering the unforced dynamics matrix, the accuracy of DMD in evaluating system stability is compromised, especially in systems like power electronics converters that are influenced by external inputs. 3. **Proposed solution**: To overcome the above issues, the paper proposes a gray-box stability analysis mechanism based on the Dynamic Mode Decomposition with control (DMDc) algorithm. This method incorporates physical constraints from the converter's state equations and uses an improved DMDc algorithm to account for the influence of external inputs. Additionally, data stacking techniques are employed to increase the dimensionality of the data matrix, ensuring that all important dynamic modes are included. 4. **Experimental validation**: The effectiveness of the proposed method is validated through an experimental platform under a low-frequency oscillation scenario of a single-phase converter. The results show that, compared to traditional DMD, the proposed gray-box DMDc method can more accurately identify dominant eigenvalues, and the analysis results are more interpretable. In summary, this study aims to provide a more accurate and interpretable method for stability monitoring and oscillation identification for power electronics converters with partially known circuit structures but unknown controllers.

A Gray-Box Stability Analysis Mechanism for Power Electronic Converters

Data-Driven Stability Assessment of Power Electronic Converters with Multi-Resolution Dynamic Mode Decomposition

Generalized Operational Short-Circuit Ratio for Grid Strength Assessment in Power Systems with High Renewable Penetration

Small-signal Stability Boundary of Heterogenous Multi-converter Power Systems Dominated by Phase-locked Loop Dynamics

On the Stability of Power Electronics-Dominated Systems: Challenges and Potential Solutions

Large-disturbance Stability for Power-Converter-dominated Microgrid: A Review

Small Signal Stability Analysis of Multi-Infeed Power Electronic Systems Based on Grid Strength Assessment

State-Space Modeling of Grid-Connected Power Converters Considering Power-Internal Voltage Characteristics

Hybrid Frequency-Domain Modeling and Stability Analysis for Power Systems with Grid-Following and Grid-Forming Converters

Dominant Mode Identification for Grey-Box Grid-Tied Converters

A Gray-Box Hierarchical Oscillatory Instability Source Identification Method of Multiple-Inverter-Fed Power Systems

An Argument-Principle Based Stability Assessment Method for Grey-Box DFIG Systems

Small Disturbance Stability Analysis of Weak-Grid-Connected DFIG-Based Wind Power System

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Quantitative Mapping of Modeling Methods for Stability Validation in Microgrids

Analysis of the Stability and System Participation Factors of Grid-Connected Converters

Analytical Switching Modelling Method of Grid-Connected Converters for Transient Stability Analysis

Modeling and Stability Analysis for Grid-Forming Converter in a Renewable Energy Generation System

A black‐box method for the stability analysis of multi‐inverter‐fed power systems using Bode diagrams

Analysis and Damping of Sub-Synchronous Oscillations for Cascaded Grid-Forming Converters Considering DC-Link Dynamics

Stability Assessment of Grid-Connected Converter System Based on Impedance Model and Gershgorin Theorem