Abstract:Seismic hazard evaluation is important for urban construction and earthquake disaster prevention and mitiga-tion. However, because of the long recurrence intervals of large earthquakes (hundreds to thousands of years), seismic hazard assessment based on relatively short-term (tens of years) observational seismic catalogs is diffi-cult. Synthetic seismic catalogs provide a useful way to assess long-term seismic hazards. Based on the Coulomb failure criterion, we apply a quasi-static physics-based earthquake simulator (Virtual Quake) in a tectonically complicated region with several major strike-slip faults, namely, the Anninghe, Zemuhe, Daliangshan and Xiaojiang (AZDX) faults, in southwestern China. The slip rates of these major faults are constrained by GPS data, and friction is constrained by laboratory experiments. Considering the stress interactions among the fault system, a synthetic catalog over 20,000 years is simulated. The simulated catalog shows consistency with the observed seismicity in the spatial distribution of large earthquakes, b value and mean seismic rate. Based on the synthetic catalog, the mean recurrence intervals and probabilities of the recurrence interval for strong earthquakes (M >= 7) in each fault section are presented in detail. Moreover, qualitative analysis of seismic hazards is conducted for the AZDX fault region. Our results provide a helpful index to evaluate seismic hazards in such a complicated region. Plain language summary: Evaluating seismic hazards is important for building codes, risk prevention and miti-gation. Because large earthquakes are rare, modern observed earthquake catalogs are too short to evaluate seismic hazards precisely. Thus, numerical simulations are used to obtain synthetic earthquake catalogs for seismic hazard evaluation. Here, we present a physics-based model of stress accumulation, transfer and release, and simulate an earthquake sequence in the Anninghe-Zemuhe-Daliangshan-Xiaojiang fault system, south -western China. Thus, we obtain a synthetic catalog over 20,000 years. By comparing the spatial distributions of large earthquakes, b values, and mean seismic rates of the synthetic catalog and observed catalog, we find that the synthetic catalog is consistent with the observed catalog. Based on the synthetic seismic catalog, we sum-marize the mean strong seismic recurrence interval and the probability of the recurrence interval for each fault section. Qualitative analysis of seismic hazards is conducted for the AZDX fault region. Our results can help to evaluate long-term seismic hazards in a multiple-fault system.

Mapping finite-fault slip with spatial correlation between seismicity and point-source Coulomb failure stress change

Spatial Relationships Between Coseismic Slip, Aseismic Afterslip, and On‐Fault Aftershock Density in Continental Earthquakes

Subduction zone fault slip from seismic noise and GPS data

Imaging Source Slip Distribution by the Back-Projection of P-wave Amplitudes from Strong-Motion Records: a Case Study for the 2010 Jiasian, Taiwan, Earthquake

Coupling 3D geodynamics and dynamic earthquake rupture: fault geometry, rheology and stresses across timescales

Seismic Versus Aseismic Slip: Probing Mechanical Properties of the Northeast Japan Subduction Zone

High‐Resolution Seismicity and Ground Motion Variability Across the Highly Locked Southern Anninghe Fault with Dense Seismic Arrays and Machine Learning Techniques

Buried Aseismic Slip and Off‐Fault Deformation on the Southernmost San Andreas Fault Triggered by the 2010 El Mayor Cucapah Earthquake Revealed by UAVSAR

Afterslip and Creep in the Rate‐Dependent Framework: Joint Inversion of Borehole Strain and GNSS Displacements for the Mw 7.1 Ridgecrest Earthquake

Refining slip distribution in moderate earthquakes using Sentinel-1 burst overlap interferometry: a case study over 2020 May 15 M w 6.5 Monte Cristo Range Earthquake

Aseismic slip and recent ruptures of persistent asperities along the Alaska-Aleutian subduction zone

Global Large Deep-Focus Earthquakes: Source Process and Cascading Failure of Shear Instability As a Unified Physical Mechanism

3D Geometry and Slip Distribution in the Long Beach Earthquake Gate, Newport–Inglewood Fault, Los Angeles, California

Estimating the Physical State of a Laboratory Slow Slipping Fault from Seismic Signals

A Two-Step Inversion for Fault Frictional Properties Using a Temporally Varying Afterslip Model and Its Application to the 2019 Ridgecrest Earthquake

Physics-based Earthquake Simulations of the Anninghe-Zemuhe-Daliangshan-Xiaojiang Fault System in Southwestern China

Insights on the dip of fault zones in Southern California from modeling of seismicity with anisotropic point processes

Fault Valving and Pore Pressure Evolution in Simulations of Earthquake Sequences and Aseismic Slip

Patterns of Causative Faults of Normal Earthquakes in the Fluid‐Rich Outer Rise of Northeastern Japan, Constrained With 3D Teleseismic Waveform Modeling

Can the regional 3D stress field according to the Wallace–Bott hypothesis predict fault slip directions of future large earthquakes?

An Updated Fault Coupling Model Along Major Block‐Bounding Faults on the Eastern and Northeastern Tibetan Plateau From a Stress‐Constrained Inversion of GPS and InSAR Data