Abstract:Signal to noise ratios (SNR) in magnetic resonance microscopy images are limited by acquisition times and the decreasing number of spins in smaller voxels. Significant SNR gains from cooling of the RF receiver are only realized when the Johnson noise generated within the RF hardware is large compared to the electromagnetic noise produced by the sample. Cryogenic cooling of imaging probes is common in high field systems but proves difficult to insulate the sample from extreme temperatures. We designed a chamber to cool only the tune and match circuitry to show it is possible to achieve much of the available SNR gain available for cooled coils. We designed a microcoil circuit to resonate at 650 MHz for imaging on a 15.2 T scanner. Surface loops and solenoids of varying diameters were tested to determine the largest diameter coil that demonstrated significant SNR gains from cooling. A liquid N2 cryochamber was designed to cool the circuitry while leaving the RF coil in ambient air. As the cryochamber was filled with liquid N2, Q-factors were measured on the bench while monitoring the coil's surface temperature. Improvements of SNR on images of solutions were demonstrated via cooling the tune and match circuit in the magnet bore. At 650 MHz, loops and solenoids < 3 mm in diameter showed significant improvements in quality factor on the bench. The resistance of the variable capacitors and the coaxial cable were measured to be 45% and 32% of room temperature values near the Larmor frequency. Images obtained with a 2 turn, 3 mm diameter loop with the matching circuit at room temperature and then cooled with liquid nitrogen demonstrated SNR improvements of a factor of 2. By cooling the tune and match circuit and leaving the surface loop in ambient air, SNR was improved by a factor of 2. The results are significant because it allows for more space to insulate the sample from extreme temperatures.

Noise Suppression with Cryogenic Resonators

Power-to-Frequency Conversion in Cryogenic Sapphire Resonators

Vibration Property of a Cryogenic Optical Resonator within a Pulse-Tube Cryostat

Tests of Sapphire Crystals Produced with Different Growth Processes for Ultra-stable Microwave Oscillators

Frequency Stable Microwave Sapphire Oscillators

Cryogenic photonic resonator with $10^{-17}$/s drift

Cryogenic sapphire optical reference cavity with crystalline coatings at 1 × 10-16 fractional frequency instability

Ultra-low-phase-noise cryocooled microwave dielectric-sapphire-resonator oscillators with 1 x 10^-16 frequency instability

Cryogenic Sapphire Oscillator using a low-vibration design pulse-tube cryocooler: First results

Ultra-low vibration pulse-tube cryocooler stabilized cryogenic sapphire oscillator with 10^-16 fractional frequency stability

Influence of the ESR saturation on the power sensitivity of cryogenic sapphire resonators

Cryogenic Microwave Filter Cavity with a Tunability Greater than 5 GHz

Unprecedented High Long Term Frequency Stability with a Macroscopic Resonator Oscillator

Cryogenic sapphire optical reference cavity with crystalline coatings at $\mathrm{ 1 \times 10^{-16}}$ fractional instability

Magnetic sensitivity of the Microwave Cryogenic Sapphire Oscillator

ELISA: a cryocooled 10 GHz oscillator with 10-15 frequency stability

Engineering the microwave to infrared noise photon flux for superconducting quantum systems

Supersonic-jet cryogenic-resonator coaxially oriented beam-resonator arrangement Fourier transform microwave spectrometer

Electromagnetic properties of polycrystalline diamond from 35K to room temperature and microwave to terahertz frequencies

Reliability and Reproducibility of the Cryogenic Sapphire Oscillator Technology

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T