Simple Calibration of Block Copolymer Melt Models

Artem Petrov,Hejin Huang,Alfredo Alexander-Katz

2024-02-29

Abstract:According to the universality hypothesis, the phase behavior of different block copolymer melt models having fixed composition depends solely on two parameters: the invariant chain length $\bar{N}$ and the effective interaction parameter $\chi N$. If models behave universally, they can be compared to each other and can predict experiment quantitatively. Here, we present a simple way to achieve this universality for coarse-grained models. Our method relies on the properties of the monomer interaction potential energy $z$ distribution. In particular, models having near-symmetric $z$-distributions exhibit universal phase behavior using the standard linear definition of the Flory-Huggins parameter $\chi\propto\alpha$, where $\alpha = \epsilon_{AB}-(\epsilon_{AA}+\epsilon_{BB})/2$, and $\epsilon_{xy}$ is the interaction energy between monomers of type $x$ and $y$. Previously, universality had been achieved using a nonlinear $\chi(\alpha)$ function which is difficult to obtain and interpret physically. The main parameter controlling the symmetry of the $z$-distribution is the monomer density $\rho$. Above certain $\rho$, models have symmetric $z$-distributions, and their order-disorder transition points follow the universal curve predicted by Fredrickson-Helfand theory in the experimentally relevant $\bar{N} > 10^2$ range. On the other hand, low-$\rho$ models exhibit skewed $z$-distributions, and the simple $\chi\propto\alpha$ formula is no longer universally applicable to them. Our results can be used for correct block copolymer model building leading to a simple and direct comparison of simulations to experiments, which will facilitate the screening of new block copolymer morphologies and support materials design.

Soft Condensed Matter

What problem does this paper attempt to address?

The problem addressed by this paper is how to achieve a simple calibration for the block copolymer melt model in order to enable different models to have universal behavior, so that simulation results can be directly compared with experiments. The research has found that when the distribution of monomer interaction potential in the model is close to symmetric, the universal behavior can be achieved by using the linearly defined Flory-Huggins parameter χ which is proportional to α. This simplifies the construction of block copolymer models and contributes to the design and screening of new block copolymer morphologies.