Stimulated Forward Brillouin Scattering in Subwavelength Silicon Membranes

Paula Nuño Ruano,Jianhao Zhang,David González-Andrade,Daniele Melati,Eric Cassan,Pavel Cheben,Laurent Vivien,Norberto Daniel Lanzillotti-Kimura,Carlos Alonso-Ramos

2024-02-24

Abstract:On-chip Brillouin scattering plays a key role in numerous applications in the domain of signal processing and microwave photonics due to the coherent bidirectional coupling between near-infrared optical signals and GHz mechanical modes, which enables selective amplification and attenuation with remarkably narrow linewidths, in the kHz to MHz range. Subwavelength periodic nanostructures provide precise control of the propagation of light and sound in silicon photonic circuits, key to maximize the efficiency of Brillouin interactions. Here, we propose and demonstrate a new subwavelength waveguide geometry allowing independent control of optical and mechanical modes. Two silicon lattices are combined, one with a subwavelength period for the light and one with a total bandgap for the sound, to confine optical and mechanical modes, respectively. Based on this approach, we experimentally demonstrate optomechanical coupling between near-infrared optical modes and GHz mechanical modes with with 5-8 MHz linewidth and a coupling strength of GB = 1360 1/(W m). A Stokes gain of 1.5 dB, and anti-Stoke loss of -2 dB are observed for a 6 mm-long waveguide with 35.5 mW of input power. We show tuning of the mechanical frequency between 5 and 8 GHz by geometrical optimization, without loss of the optomechanical coupling strength.

Optics

What problem does this paper attempt to address?

The paper attempts to address the problem of achieving efficient forward stimulated Brillouin scattering (FSBS) on silicon photonic chips to optimize the interaction between light and sound waves. Specifically, the main challenge faced by researchers is how to simultaneously control optical and mechanical modes at sub-wavelength scales to enhance Brillouin gain and reduce losses.

### Main Issues:
1. **Simultaneous Control of Optical and Mechanical Modes**:
- In traditional silicon-based photonic devices, it is difficult to effectively confine both optical and mechanical modes within the waveguide. This results in low coupling efficiency between photons and phonons, limiting the effectiveness of Brillouin scattering applications.

2. **Enhancing Brillouin Gain**:
- Researchers aim to achieve higher Brillouin gain by designing new waveguide structures to obtain significant signal enhancement within shorter waveguide lengths.

3. **Optimizing Mechanical Frequency Tunability**:
- By adjusting the geometric parameters of the waveguide, researchers aim to precisely tune the mechanical resonance frequency within the range of 5 to 8 GHz without affecting the photon-phonon coupling strength.

### Solutions:
1. **Novel Sub-Wavelength Waveguide Design**:
- A waveguide design combining sub-wavelength periodic structures and phononic crystals is proposed, achieved through a single etching process. This design allows independent control of optical and mechanical modes, improving photon-phonon coupling efficiency.

2. **Experimental Validation**:
- The effectiveness of this design was experimentally validated, demonstrating 1.5 dB Stokes gain and -2 dB anti-Stokes loss in a 6 mm long waveguide, as well as a Brillouin coefficient as high as 1360 W\(^{-1}\)m\(^{-1}\).

3. **Mechanical Frequency Tunability**:
- By altering the geometric parameters of the waveguide (such as waveguide width and sub-wavelength arm width), the mechanical resonance frequency was successfully tuned within the range of 5 to 8 GHz while maintaining high coupling efficiency.

In summary, through innovative waveguide design and experimental validation, this paper addresses the key issues of achieving efficient forward stimulated Brillouin scattering on silicon photonic chips, providing a new technical pathway for future signal processing and microwave photonics applications.