Abstract:The Raman shift of the nu(3)(SiO4) mode of zircon at -1008 cm(-1) has been observed to vary with the pressure (P) and temperature (7) of the environment. The relationship between the nu(3)(SiO4) peak position and P-T was calibrated in previous work and used to develop a pressure sensor for high P-T experiments, up to 1000 degrees C and 10 GPa, to an accuracy within +/- 50 MPa. This pressure measurement method is valid for zircon grains for which the nu(3)(SiO4) Raman shift occurs specifically at or close to 1008.17 cm(-1) at room temperature (25 degrees C). However, the peak position of nu(3)(SiO4) for some zircon grains may shift to a lower or higher wavenumber under ambient conditions, mainly due to the chemical composition of the grains. This may cause substantial deviation in the measured pressures. In the present study, we recalibrated the pressure sensor by determining the position of the nu(3)(SiO4) peak for zircon grains with different chemical compositions at given P-T conditions and developed a model applicable to both natural and synthetic zircon samples. All the zircon samples considered were found to have a universal nu-T relationship when the nu(3)(SiO4) wavenumbers under ambient conditions were calibrated to the same position. Based on this relationship, the temperature-induced wavenumber shift of nu(3)(SiO4) can be expressed as Delta nu(T) (cm(-1)) = 8.00 x 10(-9) x (T-3 - T-o(3))- 2.00 x 10(-5) x (T2 - T-o(2))- 2.78 x 10(-2) x (T - T-o), where T and T-0 are the target and room temperatures, respectively. In addition, the pressure-induced wavenumber shift of nu(3)(SiO4) can be calculated using Delta nu(P) (cm(-1)) = Delta nu - Delta nu(T), where Av is the total frequency shift between the target and ambient P-T conditions. By the linear regression of the experimental results, the global slope (partial derivative nu/partial derivative P)(T) was determined to be 5.91 x 10(-3) cm(-1)/MPa. In addition, high P-T experiments performed in isochoric systems using a hydrothermal diamond anvil cell (HDAC) showed that the cross-derivative term (partial derivative(2)nu/partial derivative P partial derivative T) was equal to zero, which is the same as the previous study. The revised method was used to determine the pressures inside a fused silica capillary capsule (FSCC) containing a NaCl solution. The pressures determined from the zircon Raman spectra (P-zr) were compared with those calculated using the equation of state (P-Eos) of a NaCl-H2O system. The determined P-Zr and P-Eos values agreed well for temperatures lower than similar to 500 degrees C. However, P. was significantly lower than P-Eos at higher temperatures due to the thermal expansion of the FSCC, i.e., the expansion of the sample chamber under the high internal pressures when the silica glass softened at high temperatures. The revised method was programmed in a Microsoft EXCEL spreadsheet and is presented in the Appendix B.

Realization of the Pascal based on Argon using a Fabry-Pérot refractometer

Pascal Realization by Comb-Spectral-Interferometry Based Refractometer

Brillouin Scattering Studies Of Liquid Argon At High Temperatures And High Pressures

Theoretical determination of the polarizability dispersion and the refractive index of helium

Hydrostaticity of pressure-transmitting media for high pressure infrared spectroscopy

Vacuum metrology based on refractive index of gas

Updated determination of the molar gas constant $R$ by acoustic measurements in argon at UVa-CEM

The Equation of State of Dense Argon: A Comparison of Shock and Static Studies

Acoustic Velocity and Refractive-Index of Fluid Hydrogen and Deuterium at High-Pressures

Thermophysical properties of argon gas from improved two-body interaction potential

Realisation of the triple-point of Argon: comparison between two devices

Strength, Anisotropy, and Preferred Orientation of Solid Argon at High Pressures.

Realization of ppm level pressure stability for primary thermometry using a primary piston gauge

Reassessment of the Zircon Raman Spectroscopic Pressure Sensor and Application to Pressure Determination of Fused Silica Capillary Capsule

Design and Performance of an Absolute Gas Refractometer Based on a Synthetic Pseudo-Wavelength Method.

Transport properties of dense fluid argon

Measurement of Casimir-Polder interaction for slow atoms through a material grating

Modulus-Pressure Equation for Confined Fluids

The Use of Triple Point of Gases in Sealed Cells as Pressure Transfer Standards: Oxygen (146.25 Pa), Methane (11,696 Pa) and Argon (68,890 Pa)

All-optical method to directly measure the pressure-volume-temperature equation of state of fluids in the diamond anvil cell

Determination of Pressure in Aqueo-Carbonic Fluid Inclusions at High Temperatures from Measured Raman Frequency Shifts of CO2