Beam Squinting Compensation: An NCR-Assisted Scenario

Diego A. Sousa,Fco. Rafael M. Lima,Victor F. Monteiro,Tarcisio F. Maciel,Behrooz Makki

2024-02-16

Abstract:Millimeter wave (mmWave) and sub-THz communications, foreseen for sixth generation (6G), suffer from high propagation losses which affect the network coverage. To address this point, smart entities such as network-controlled repeaters (NCRs) have been considered as cost-efficient solutions for coverage extension. NCRs, which have been standardized in 3rd generation partnership project Release 18, are radio frequency repeaters with beamforming capability controlled by the network through side control information. Another challenge raised by the adoption of high frequency bands is the use of large bandwidths. Here, a common configuration is to divide a large frequency band into multiple smaller subbands. In this context, we consider a scenario with NCRs where signaling related to measurements used for radio resource management is transmitted in one subband centered at frequency $f_c$ and data transmission is performed at a different frequency $f_c + \Delta f$ based on the measurements taken at $f_c$. Here, a challenge is that the array radiation pattern can be frequency dependent and, therefore, lead to beam misalignment, called beam squinting. We characterize beam squinting in the context of subband operation and propose a solution where the beam patterns to be employed at a given subband can be adjusted/compensated to mitigate beam squinting. Our results show that, without compensation, the perceived signal to interference-plus-noise ratio (SINR) and so the throughput can be substantially decreased due to beam squinting. However, with our proposed compensation method, the system is able to support NCR subband signaling operation with similar performance as if signaling and data were transmitted at the same frequency.

Signal Processing

What problem does this paper attempt to address?

This paper attempts to solve the beam squinting problem caused by the frequency - dependent antenna array radiation pattern when using network - controlled repeaters (NCRs) in millimeter - wave (mmWave) and sub - terahertz (sub - THz) communications. Specifically, when signal transmission and data transmission are carried out in different sub - bands respectively, beam squinting will lead to an increase in signal interference, thereby reducing the signal - to - interference - plus - noise ratio (SINR) and throughput of the system. To solve this problem, the paper proposes a beam squinting compensation method to mitigate the impact of beam squinting by adjusting the beam pattern in specific sub - bands. Research shows that this compensation method enables the system to maintain performance similar to that of single - band operation in different sub - bands.

### Background and Problems of the Paper
1. **Challenges in High - Frequency Communications**:
- Millimeter - wave (mmWave) and sub - terahertz (sub - THz) communications are important components of sixth - generation (6G) wireless communications, but the propagation losses in these high - frequency bands are very high, affecting network coverage.
- To extend the coverage range, network - controlled repeaters (NCRs) are introduced as a cost - effective solution.

2. **Use of Large Bandwidth**:
- High - frequency bands usually need to use large bandwidth, which causes user equipment (UE) to need to perform more measurements on a wider frequency band, increasing battery consumption.
- To solve this problem, the large bandwidth is usually divided into multiple smaller sub - bands.

3. **Beam Squinting**:
- When signal transmission and data transmission are carried out in different sub - bands, due to the fact that the radiation pattern of the antenna array changes with frequency, beam squinting may occur.
- Beam squinting will lead to main lobe offset and an increase in system interference, thereby reducing SINR and throughput.

### Objectives of the Paper
The main objectives of the paper are:
- **Analyze the Beam Squinting Phenomenon**: Analyze in detail the impact of beam squinting on system performance in the context of sub - band operation.
- **Propose a Compensation Method**: Design a beam squinting compensation method to mitigate the impact of beam squinting by adjusting the beam pattern in specific sub - bands.
- **Verify the Effect**: Evaluate the system performance of the proposed compensation method under different carrier frequency offsets through simulation to prove its effectiveness and feasibility.

### Main Contributions
1. **Characterization of Beam Squinting**: Analyze in detail the performance of beam squinting at different frequencies, especially the impact in sub - band operation.
2. **Design of the Compensation Method**: Propose a method based on phase deviation compensation to correct beam squinting by adjusting filter weights.
3. **System - level Performance Evaluation**: Demonstrate the impact of beam squinting on system performance through simulation and verify the effectiveness of the proposed compensation method.

### Conclusion
The paper successfully solves the beam squinting problem when using sub - band operation in NCR - assisted networks. Through the proposed compensation method, the system can maintain performance similar to that of single - band operation in different sub - bands, significantly improving the reliability and efficiency of the system.