Optimization of laser pumping for the generation of multi-pulse structures in fiber lasers

A. Malfondet,G. Millot,P. Grelu,P. Tchofo-Dinda

DOI: https://doi.org/10.1364/JOSAB.513595

2024-02-12

Abstract:We address the challenge of configuring a fiber laser cavity to enable efficient access to multi-pulse structures such as dissipative soliton molecules. We theoretically compare multi-pulsing routes in the parameter space of the laser. By using a two-dimensional parameter space, we experimentally demonstrate an important reduction in the laser pumping power required to form soliton molecules.

Optics

What problem does this paper attempt to address?

This paper mainly discusses how to optimize the cavity design of fiber lasers to efficiently generate multi-pulse structures, especially dissipative soliton molecules. In the study, the authors compared the multi-pulse generation paths under different parameter spaces through theoretical analysis and experiments. They found that by adjusting the center wavelength of the tunable bandpass filter (BPF) to be close to the effective peak gain (1.53 micrometers) of the erbium-doped fiber amplifier (EDFA), the pump power required to form the multi-pulse structure can be significantly reduced.

In traditional methods, the generation of multi-pulse structures requires gradually increasing the pump power, resulting in higher peak power inside the cavity, which may exacerbate non-linear effects and pulse profile distortion. The paper pointed out that it was previously proposed in theory to use a tunable BPF to eliminate these distortions while reducing the pump power, but lacked experimental verification. The experimental results confirmed the feasibility of this concept, and by adjusting the center wavelength of the BPF from 1.55 micrometers to 1.534 micrometers, the pump power requirement was greatly reduced, even below the threshold of a cavity without BPF.

Numerical simulations showed that for a Gaussian-type BPF with a center wavelength of 1.534 micrometers, lower fragmentation pump power (FPP) could be achieved, and within certain bandwidth ranges, the reduction of the BPF's non-linear loss was sufficient to offset the linear loss it introduced, making FPP comparable or lower than that of a cavity without BPF. In addition, by using two-dimensional parameter space optimization technique (2D-OT), FPP could be further reduced and pulse profile distortion minimized.

The experimental part verified the effectiveness of 2D-OT, indicating that multi-pulse structures could be generated by adjusting the center wavelength and bandwidth of the BPF at lower pump power. This provides a new approach for controlling and manipulating multi-dissipative soliton states in ultrafast fiber lasers, reducing operational complexity and energy requirements.