Simulation and Experimental Analysis of Aerogel Attenuation for High Energy Alpha Particles in Fission Fusion Fragment Rocket Applications

Sandeep Puri,Andrew Gillespie,Ian Jones,Cuikun Lin,Ryan Weed,Robert V. Duncan

2024-05-29

Abstract:Emerging studies are geared toward exploring new methods of nuclear rocket propulsion to provide more efficient space transit beyond Earth's orbit. One method is to employ a Fission Fragment Rocket Engine utilizing fissionable layers embedded in a low-density aerogel. A quantitative understanding of particle attenuation is essential for developing a functional prototype that permits fission fragments to escape the layers and contribute to specific impulse rather than being attenuated and generating waste heat. In this investigation, the MCNP code was used to theoretically analyze the attenuation of alpha particles from Am-241 sources within aerogel materials. Simulations were conducted on aerogels with various densities and compositions. These simulations aimed to predict the expected intensity of alpha particles reaching a detector. CR-39 was employed as a Plastic Nuclear Track Detector to assess particle attenuation by the aerogels. The threshold areal density of atoms was found to be around $10^{ 20}$ atoms/$cm^{ 2}$ for the three materials studied in this project. Using a 0.22 mm thick SiO$_2$ aerogel with a density of 90 mg/$cm^{ 3}$, which exceeds the threshold, nearly all alpha particles were attenuated. Conversely, employing a 1.6 mm thick graphene aerogel with a density of 12.5 mg/$cm^{ 3}$ resulted in an average attenuation of 32.3%.

Instrumentation and Detectors

What problem does this paper attempt to address?

This paper mainly discusses the simulation and experimental analysis of gas gel attenuation of high-energy alpha particles in the application of fission-fusion rocket engines. The study aims to understand how to design functional prototypes that allow fission fragments to escape thin layers without generating waste heat, in order to improve the thrust and specific impulse of nuclear rockets. The authors used the MCNP code to theoretically analyze the attenuation of alpha particles in gas gel materials of different densities and compositions, and evaluated it experimentally using a CR-39 plastic nuclear track detector.

The paper points out that one of the health risks faced by human spaceflight missions is ionizing space radiation, while nuclear rocket propulsion systems may offer more efficient space travel. Among them, the fission fragment rocket engine utilizes a fission layer embedded in low-density aerogel, but it is necessary to avoid rapid deceleration of fragments in solid substances. The study found that the atomic areal density threshold of aerogel is about 10²⁰ atoms/cm². When it exceeds this threshold, almost all alpha particles will be attenuated. For example, a 0.22 mm thick SiO₂ aerogel (density 90 mg/cm³) almost completely attenuates alpha particles, while a 1.6 mm thick graphene aerogel (density 12.5 mg/cm³) attenuates an average of 32.3%.

In the experimental part, CR-39 was used as a plastic nuclear track detector to measure the attenuation of alpha particles by different aerogel materials. Through Monte Carlo simulation (MCNP 6.2), the expected intensity of alpha particles reaching the detector was predicted. The results showed that there is a significant threshold for aerogel density at around 20 mg/cm³ for alpha particles emitted by a 241Am source. Below this threshold, alpha particles can almost fully transmit, while above this threshold, most of them are attenuated.

Future research will involve the use of actual 235U fission fragments to evaluate the feasibility of submicron fuel in aerogels, as well as the study of aerogel heterogeneity, heating issues, Joule aerogels, and optimized magnetic configurations.