A Novel Geometric Solution for Moving Target Localization through Multistatic Sensing in the ISAC System

S. Zhuge,Y. Ma,Z. Lin,Y. Zeng

2024-01-29

Abstract:This paper proposes a novel geometric solution for tracking a moving target through multistatic sensing. In contrast to existing two-step weighted least square (2SWLS) methods which use the bistatic range (BR) and bistatic range rate (BRR) measurements, the proposed method incorporates an additional direction of arrival (DOA) measurement of the target obtained from a communication receiver in an integrated sensing and communication (ISAC) system. Unlike the existing 2SWLS methods that require at least three transmitter-receiver (TX-RX) pairs to operate, the proposed algorithm can conduct location estimation with a single TX-RX pair and velocity estimation with two TX-RX pairs. Simulations reveal that the proposed method exhibits superior performance compared to existing 2SWLS methods, particularly when dealing with moderate levels of noise in DOA measurements.

Signal Processing,Systems and Control

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the problem of locating mobile targets through multi - static sensing techniques in the Integrated Sensing and Communication (ISAC) system. Specifically, the existing two - step weighted least - squares (2SWLS) method requires at least three transmitter - receiver (TX - RX) pairs to function properly when using bistatic range (BR) and bistatic range rate (BRR) measurements for target location. However, these methods do not fully utilize the direction - of - arrival (DOA) measurements obtained from communication receivers. Therefore, the paper proposes a new geometric solution that can not only utilize BR, BRR, and DOA measurements, but also estimate the target position with only one TX - RX pair and estimate the target velocity with only two TX - RX pairs. This method exhibits better performance than the existing 2SWLS method when dealing with a moderate level of DOA measurement noise.

The main contributions of the paper include:
1. Proposing a new representation method to describe the geometric relationships among the transmitter, the target, and the receiver, so that the position of the unknown target can be expressed based on all known parameters.
2. Developing a new multi - static sensing algorithm that can estimate the target position with only one TX - RX pair and estimate the target velocity with only two TX - RX pairs, which is fewer than the at least three TX - RX pairs required by the existing 2SWLS method.
3. Simulation results show that when the DOA measurement error is moderate, the proposed algorithm is superior to the existing 2SWLS method in terms of the root - mean - square error (RMSE) of position and velocity estimation.

Through these improvements, the paper provides a more efficient and practical method for locating mobile targets, especially when the number of available TX - RX pairs is limited.