Abstract:Recently, indoor localization using a single receiver has received significant attention. Despite the improvement of this, developing an accurate and universal system is still heavily required. In this article, we design and implement BiLoc, a decimeter level indoor localization system with hybrid measurements of a distributed single receiver. Specifically, different from the existing single receiver-based localization system, in BiLoc, some antennas of the array on the single receiver are distributed at different locations. To this end, BiLoc is based on the fact that the paths recorded on the same receiver incur common phase errors that are caused by nonsynchronization between the transmitter and the receiver. In BiLoc, first, some antennas of the antenna array are moved to different locations to locate the target. Then, BiLoc uses the 2-D matrix pencil (MP) to estimate the Angle of Arrival (AoA) and Time of Flight (ToF) of the multipath signals, which reduces the computational complexity effectively. After that, BiLoc constructs a nonlinear localization model by using the ToFs of the paths received at different antennas and AoAs measured at the antenna array, and then, an iterative algorithm based on the gradient of the localization objective function is used to solve this nonlinear problem. Because of combining hybrid AoA and ToF measurements, the proposed localization method is no longer sensitive to the selection of the initial guess of the target location. Finally, we implement BiLoc on the software-defined radio (SDR) X310 devices, and the designed prototype has six antennas with a maximum signal bandwidth of 100 MHz. The extensive experiments conducted in the practical indoor environments show that BiLoc achieves a median accuracy of 5 dm, which is comparable to the existing localization systems with decimeter level accuracy, and the localization delay is less than 100 ms. We believe that BiLoc can perform better in the emerging networks, such as 5G, becau-e wider bandwidth and more antennas can be provided.

Near-Field Localization with $1$-bit Quantized Hybrid A/D Reception

A Hybrid Beamforming Receiver with Two-Stage Analog Combining and Low-Resolution ADCs

Circuit-Compliant Optimization of Dynamic Metasurface Antennas for Near-Field Localization

Efficient Localization of Low-Frequency Sound Source with Non-Synchronous Measurement at Coprime Positions by Alternating Direction Method of Multipliers.

Channel-Aware Direct Localization Using One-Bit Quantized Measurements

A Low Complexity UWB Localization Algorithm Using Finite-Resolution Quantization

Beam Focusing for Near-Field Multi-User Localization

Hybrid Architectures with Few-Bit ADC Receivers: Achievable Rates and Energy-Rate Tradeoffs

Enhancing Direct Position Determination in Distributed Base Station Systems through Time-Varying Quantization Design

Direct Target Localization with Quantized Measurements in Noncoherent Distributed MIMO Radar Systems.

Detection and Localization of One-Bit Signal in Multiple Distributed Subarray Systems.

Low-Complexity Mobile User Tracking in Quantized mmWave MIMO Systems

Majorization–Minimization Based Direct Localization Using One-Bit Channel Measurements

Near-Field Localization with Antenna Arrays in the Presence of Direction-Dependent Mutual Coupling

Multiuser Detection for Uplink Large-Scale MIMO under One-Bit Quantization.

Decimeter Level Indoor Localization Using Hybrid Measurements of a Distributed Single Receiver

Localization in Reconfigurable Intelligent Surface Aided mmWave Systems: A Multiple Measurement Vector Based Channel Estimation Method

Metasurface-Based Receivers with $1$-bit ADCs for Multi-User Uplink Communications

Joint UWB TOA and AOA estimation under 1-bit quantization resolution

Enhanced Uplink Data Detection for Massive MIMO with 1-Bit ADCs: Analysis and Joint Detection

Machine Learning-based Near-field Emitter Location Sensing via Grouped Hybrid Analog and Digital XL-MIMO Receive Array