Abstract:The values of pressure (P), the temperature derivative, gamma(v) = (partial derivative P/partial derivative T)(v), and the density (rho) of benzene have been simultaneously measured in the near- and supercritical regions using high-temperature and high-pressure piezo-calorimeter. Measurements were made along 10 liquid and vapor isochores between (265.5 and 653.9) kg.m(-3) and at temperatures from (346.03 to 615.92) K and at pressures up to 9.171 MPa. For each isochore most measurements were made in the immediate vicinity of the liquid-gas phase transition temperature (single- and two-phase regions) where the break of the P-T isochores and the jumps of the thermal-pressure coefficient gamma(v) are observing. Temperatures and pressures (T-s, P-s) at the liquid-gas phase transition curve for each constant density (isochore, rho) and the critical parameters (T-C,P-C,rho(C)) for benzene were measured using the isochoric P - T break point and thermal -pressure coefficient jump techniques. The expanded uncertainty of the pressure (P), density (rho), and thermal -pressure coefficient (gamma(v)) measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be, 0.16%, 0.05% and (0.12 to 1.5) % (depending on temperature and pressure), respectively. The measured pressures (PVT) and thermal -pressure coefficients (gamma vVT) have been used to calculate of the internal pressure (or energy-volume coefficient) as (partial derivative U/partial derivative V)(T) = T(partial derivative P/partial derivative T)(v) -P. We have also measured the temperature derivatives of the internal energy (partial derivative U/partial derivative V)(v) = C-v (isochoric heat capacity) using the same piezocalorimetric cell. The effect of pressure and temperature on the internal pressure was studied. isochoric P-T curve break point and isochoric thermal-pressure coefficient jump techniques were used to accurately determine of the phase transition and critical points parameters. The measured values of the thermal-pressure coefficient were interpreted in term of scaling theory of critical phenomena. The measured values of pressure (P), temperature derivative, (partial derivative P/partial derivative T)(v), temperature and density at the saturation curve together with our previous isochoric heat capacity measurements were used to calculate other thermodynamic properties of benzene at saturation curve. (C) 2019 Elsevier B.V. All rights reserved.

Isothermal VLE ( PTxy ) measurements and modeling of the high-pressure and high-temperature phase behavior of SC CO 2 + aniline mixture using the PC-SAFT and PR equations of state

Measurement And Modeling Of The High-Pressure Phase Behavior Of The Carbon Dioxide Plus Propene Oxide Binary System

High-Pressure Vapor–Liquid Equilibria for a CO2 + P-Cymene Binary System at Temperatures from 313.15 to 353.15 K

Experimental Data and Description of the Phase Equilibrium in the Binary System of Ethyl Fluoride and Polyol Ester Oil (planetelf ACD 32)

An experimental study of PVTx properties in the gas phase for binary mixtures of HFO-1234yf and HFC-134a

Isothermal Vapor-Liquid Equilibrium Of (Pentafluoroethane Plus Fluoroethane) At Temperatures Between (265.15 And 303.15) K Obtained With A Recirculating Still

Vapor-liquid Equilibrium Measurements for Binary Mixtures of Carbon Dioxide (Co2)+2,3,3,3-Tetrafluoroprop-1-ene (R-1234Yf) and Carbon Dioxide (Co2)+3,3,3-Trifluoropropene (R-1243Zf)

Phase equilibria for the carbon dioxide + cyclopentane + cyclohexane system at high pressures

Vapor-liquid equilibrium measurement for carbon dioxide (CO 2 )+propylene (R1270) binary mixture at temperatures from subcritical to supercritical

Investigation on Vapor–Liquid Equilibrium of (Argon + Methane) at the Temperature Range of (95 to 135) K

Vapor–Liquid Equilibrium for the Mixture Methane (CH4) + Ethane (C2H6) over the Temperature Range (126.01 to 140.01) K

Measurement and Modeling the Properties and Equilibrium of Fluid Systems Involving Carbon Dioxide and Hydrocarbons

Elastic Stability of CO_{2} Phase I under High Temperature and Pressure

Phase Equilibrium in an Octadecane–Propane/n-Butane System

Vapor-liquid Equilibrium Measurement for Carbon Dioxide (co2)+propylene (R1270) Binary Mixture at Temperatures from Subcritical to Supercritical

Research on Binary Phase Equilibrium for 1-Methylnaphthalene + CO2

Vapor-liquid Equilibrium Measurement and Critical Line Prediction for Carbon Dioxide (CO2) + Fluoroethane (R161) Binary Mixtures

Vapor–Liquid Equilibrium Data for Binary Systems CO 2 + Acetone, Butanone, 2-Pentanone, and 3-Pentanone at 253.15 K: Experimental Measurements and Correlations

Simultaneously Measurements of the PVT and Thermal – Pressure Coefficient of Benzene in the Critical and Supercritical Regions

Measurements and Correlation of Vapor-Liquid Equilibrium for Difluoromethane (R-32)+2,3,3,3-tetrafluoroprop-1-ene (R-1234Yf) and Pentafluoroethane (R-125) + Propane (R-290)

Isobaric Vapor-Liquid Equilibrium Data for Tetrahydrofuran + Acetic Acid and Tetrahydrofuran + Trichloroethylene Mixtures