Abstract:Carbon dots have many new and interesting phenomena, and the concentration dependent luminescence wavelength is an intriguing one. Herein, nitrogen-sulfur co-doped carbon dots (NSCDs) diluted to different concentrations, the high concentration of G-NSCDs (0.2 mg mL−1) with green fluorescence and the low-concentration of B-NSCDs (0.01 mg mL−1) with blue fluorescence were obtained. Further, it was found that the detection behaviors are different for different concentrations. The “turn-off” fluorescent sensor of G-NSCDs can specifically recognize rifampicin in a linear range of 0.2–20 μM with a detection limit of 56.6 nM employing the mutual effect of photo-induced electron transfer and dynamic quenching. Meanwhile, a “turn-off” B-NSCDs fluorescence sensor was constructed to effectively identify morin based on the internal filtration effect and static quenching, achieving a suitable linearity of 0.2–30 μM and a detection limit of 51.2 nM. Due to the strong chelation of morin and Al3+, a “turn-on” fluorescent probe for sequential detection Al3+ was fabricated based on B-NSCDs-morin system, obtaining a good linearity of 0.1–2.0 μM with a satisfactory detection limit of 45.8 nM. These interesting behaviors indicate that NSCDs are expected to become novel sensing materials for the monitoring of rifampicin, morin and Al3+ in organisms, which is beneficial for our health.

A red fluorescent carbon dots with good water solubility for rapid detection of Al3+ in actual samples

N-doped carbon dots for the determination of Al3+ and Fe3+ using aggregation-induced emission

A Carbon Dots/rutin System for Colorimetric and Fluorimetric Dual Mode Detection of Al3+ in Aqueous Solution

Hydrothermal synthesis of dual emission carbon dots with yellow fluorescence for ratio detection of Al 3+

Red fluorescent carbon dots for sensitive and selective detection and reduction of Au3+

Acid-assisted hydrothermal synthesis of red fluorescent carbon dots for sensitive detection of Fe(III)

Highly Sensitive and Selective Detection of Fe 3+ by Utilizing Carbon Quantum Dots As Fluorescent Probes

Low-Cost Synthesis of Carbon Nanodots from Natural Products Used As A Fluorescent Probe for the Detection of Ferrum(Iii) Ions in Lake Water

Red-emitting carbon dots aggregates–based fluorescent probe for monitoring Cu2+

Synthesis of N,S co-doped carbon dots for fluorescence turn-on detection of Fe2+ and Al3+ in a wide pH range

High photoluminescent carbon nanodots and quercetin-Al3+ construct a ratiometric fluorescent sensing system

Facile Synthesis of Green Fluorescent Carbon Dots and Their Application to Fe3+ Detection in Aqueous Solutions

Concentration-regulated multi-color fluorescent carbon dots for the detection of rifampicin, morin and Al3+

Concentration-regulated multi-color fluorescent carbon dots for the detection of rifampicin, morin and Al 3 +

Preparation of Microcrystalline Cellulose-Derived Carbon Dots as a Sensor for Fe3+ Detection

One step synthesis of red light-emitting carbon dots (R-CDs) with highly photoluminescence from O-phenylenediamine and 2,4-diaminophenol as fluorescent probes for detection of pH and Cr (VI)

Facile synthesis of carbon dots with blue-emitting for fluorescence determination of alizarin yellow R and temperature

Red Emitting Nitrogen-Doped Carbon Dots for Fluorescence and Colorimetric Dual-Mode Detection of Cu 2+ and Biological Sensing

Controllable Preparation of Long Wavelength Carbon Dots and its Application in Fluorescence Detection

Solid-Phase Synthesis of Red Fluorescent Carbon Dots for the Dual-Mode Detection of Hexavalent Chromium and Cell Imaging

Red-emitting Carbon Dots for Fluorescent and Smartphone-Assisted Dual-Mode Detection of Cu(II), Hg(II), and Fe(III) and Investigation of the Sensing Mechanism