Abstract:This work for the first time addresses the feasibility of measuring millihertz gravitational waves (mHz GWs) with a storage ring-based detector. While this overall challenge consists of several partial problems, here we focus solely on quantifying design limitations imposed by the kinetic energy and radiated power of circulating ions at relativistic velocities. We propose an experiment based on the measurement of the time-of-flight signal of an ion chain. One of the dominant noise sources inherent to the measurement principle for such a GW detector is the shot noise of the emitted synchrotron radiation. We compute the noise amplitude of arrival time signals obtained by analytical estimates and simulations of ions with different masses and velocities circulating in a storage ring with the circumference of the Large Hadron Collider (LHC). Thereby, we show that our experiment design could reduce the noise amplitude due to the synchrotron radiation in the frequency range $10^{-4} - 10^{-2}$ Hz to one or two orders of magnitude below the expected GW signals from of astrophysical sources, such as super-massive binary black holes or extreme mass-ratio inspirals. Other key requirements for building a working storage ring-based GW detector include the generation and acceleration of heavy ion chains with the required energy resolution, their injection and continued storage, as well as the detection method to be used for the determination of the particle arrival time. However, these are not the focus of the work presented here, in which we instead concentrate on the definition of a working principle in terms of ion type, kinetic energy, and ring design, which will later serve as a starting point when addressing a more complete experimental setup.

Study of a cubic cavity resonator for gravitational waves detection in the microwave frequency range

Detecting High-Frequency Gravitational Waves with Microwave Cavities

Cavity Detection of Gravitational Waves: Where Do We Stand?

Novel high-frequency gravitational waves detection with split cavity

First characterisation of the MAGO cavity, a superconducting RF detector for kHz-MHz gravitational waves

High-Frequency Gravitational-Wave Detection Using a Chiral Resonant Mechanical Element and a Short Unstable Optical Cavity

MAGO$\,$2.0: Electromagnetic Cavities as Mechanical Bars for Gravitational Waves

Merging L-shaped resonator with Michelson configuration for kilohertz gravitational-wave detection

Electromagnetic field in a cavity induced by gravitational waves

The Global Network of Cavities to Search for Gravitational Waves (GravNet): A novel scheme to hunt gravitational waves signatures from the early universe

Using A Polarized Maser to Detect High-Frequency Relic Gravitational Waves

Searching for High Frequency Gravitational Waves with Phonons

Gravitational wave detectors with broadband high frequency sensitivity

Simultaneous Resonant and Broadband Detection of Ultralight Dark Matter and High-Frequency Gravitational Waves via Cavities and Circuits

Detecting Planetary-mass Primordial Black Holes with Resonant Electromagnetic Gravitational Wave Detectors

Concept Study of a Storage Ring-based Gravitational Wave Observatory: Gravitational Wave Strain and Synchrotron Radiation Noise

Resonant behavior and stability of a linear three-mirror cavity

Searching for high-frequency gravitational waves by ground high field magnetic resonant sweepings

Study of the different responsive behaviour of the sidebands in LIGO I