Abstract:Most nuclear power plants (NPPs) are looking deploying digital instrumentation and control (I&C) systems, which allow for more precise control and more economical operation. However, both the quantity and capability of industrial control system (ICS)-targeted cyber-attacks have grown dramatically over recent years. Therefore, one of the most significant challenges that digital I&C systems bring is the issue of cybersecurity, which should be enhanced before their deployment.Several different types of cyber-attacks can be introduced to NPPs; a false data injection attack on key equipment is the focus of this research due to the potential severe consequences associated with such an attack. In false data injection, the attackers may alter the reading of control sensors or commands to change the operation of an NPP. Current cybersecurity efforts focus on intrusion prevention by firewalls or data-flow direction control and use commercial intrusion detection systems, which usually focus on monitoring Internet Protocol (IP) addresses, ports, and payload length. However, attention should be given to conditions where these approaches can fail, such as an insider attack. Previous research based on process data shows the potential of a last defenseâ, line using online monitoring of the process data in concern with cyber data analysis. However, existing models involve different subsystems across the whole NPP, which has a wide attack surface and may require high computing cost. This holistic approach may not meet the time-sensitive requirements imposed upon I&C systems. This paper proposes a localized kit for key equipment in a process as a complementary detection method to improve the robustness of key equipment under cyber-attacks. Compared to existing models, this reduces the number of variables used in the model and significantly improves the computational speed. It also reduces the attack surface by limiting the data acquisition locally. This localized kit includes a cyber-attack detection model to detect anomalies within key components, such as the control system actuator, and an inference model to potentially reconstruct a compromised signal to allow the safe shut down.To develop and demonstrate the localized cybersecurity kit, a hardware-in-the-loop (HIL) testbed was built with a pressurized water reactor (PWR) simulator and a programmable logical controller (PLC). The PLC was programmed to control the steam generator (SG) water level at a specified set point, and the PWR simulator was utilized to simulate the nuclear system and response for parameters outside of the SG. Three false data injection attacks were conducted towards the testbed to generate the data needed for the localized kit development and evaluation. The results show the cyber-attack detection model is effective under false data injection scenarios and the inference model is promising as a signal reconstruction method.

Diagnostics Using Nuclear Plant Cyber Attack Analysis Toolkit

Robust localized cyber-attack detection for key equipment in nuclear power plants

Vulnerability Assessment of Electrical Cyber-Physical Systems Against Cyber Attacks

Cyber Attack Detection of I&C Systems in NPPS Based on Physical Process Data

Real-time simulations to enhance distributed on-line monitoring and fault detection in Pressurized Water Reactors

False-Data-Injection-Enabled Network Parameter Modifications in Power Systems: Attack and Detection

Multi-Objective False Data Injection Attacks of Cyber–Physical Power Systems

Anomaly Detection and Analysis in Nuclear Power Plants

NIPAD: a Non-Invasive Power-Based Anomaly Detection Scheme for Programmable Logic Controllers

Analysis of AP1000 Small-Break Loss-of-Coolant Accident Using Reactor Transient Simulator

Demo Abstract: A HIL Emulator-Based Cyber Security Testbed for DC Microgrids

Development and Application of an Extensible Engineering Simulator for NPP DCS Closed-Loop Test

Kernel Principle Component Analysis and Random Under Sampling Boost Based Fault Diagnosis Method and its Application to a Pressurized Water Reactor

Dynamic Data Injection Attack Detection of Cyber Physical Power Systems with Uncertainties

Integrated Safety and Security Analysis of Nuclear Power Plants Using Dynamic Event Trees

Development of a Surrogate System of a Plant Dynamics Simulation Model and an Abnormal Situation Identification System for Nuclear Power Plants Using Deep Neural Networks

Development of a leading simulator/trailing simulator methodology as part of an integrated safety-security analysis for nuclear power plants

Python TensorFlow Big Data Analysis for the Security of Korean Nuclear Power Plants

Mathematical modeling of a steam generator for sensor fault detection

A system diagnostic and prognostic framework based on deep learning for advanced reactors

Transient Thermal-Hydraulic Characteristics Analysis Software for PWR Nuclear Power Systems