Abstract:The sensitivity of aLIGO detectors is adversely affected by the presence of noise caused by light scattering. Low frequency seismic disturbances can create higher frequency scattering noise adversely impacting the frequency band in which we detect gravitational waves. In this paper, we analyze instances of a type of scattered light noise we call "Fast Scatter" that is produced by motion at frequencies greater than 1 Hz, to locate surfaces in the detector that may be responsible for the noise. We model the phase noise to better understand the relationship between increases in seismic noise near the site and the resulting Fast Scatter observed. We find that mechanical damping of the Arm Cavity Baffles (ACBs) led to a significant reduction of this noise in recent data. For a similar degree of seismic motion in the 1-3 Hz range, the rate of noise transients is reduced by a factor of ~ 50.

What problem does this paper attempt to address?

### What problem does this paper attempt to solve? This paper aims to solve the high - frequency noise problem caused by light scattering in the LIGO Livingston Observatory. Specifically, the author focuses on the high - frequency scattering noise (called "Fast Scatter") caused by low - frequency seismic disturbances. This noise can seriously affect the sensitivity of LIGO detectors in the gravitational - wave detection frequency range. #### Main problems: 1. **Influence of light - scattering noise**: - Light - scattering noise (especially high - frequency scattering noise) can cause gravitational - wave signals to be masked, thus affecting parameter estimation and may trigger false alarms. - This noise has a negative impact on the sensitivity of LIGO detectors, especially in the frequency range from 10 Hz to 100 Hz. 2. **Identification and modeling of noise sources**: - The author analyzes different types of scattering noise, especially "Fast Scatter", and attempts to determine its causes and mechanisms. - By modeling phase noise and amplitude noise, the research team hopes to better understand the relationship between seismic noise and scattering noise. 3. **Effect evaluation of noise mitigation measures**: - Researchers tested the effect of mechanical damping on arm - cavity baffles (ACBs) and found that this method significantly reduces scattering noise. - Comparing seismic movements of similar magnitudes, the noise transient rate is reduced by about 50 times in the 1 - 3 Hz range. #### The core objectives of the paper are: - **Identify and quantify the sources of high - frequency scattering noise**: By analyzing different types of scattering noise and their correlation with ground motion, find specific noise sources. - **Establish a noise model**: Use mathematical formulas (such as expressions for phase noise and amplitude noise) to describe the generation mechanism of scattering noise. - **Propose effective noise mitigation measures**: Verify the effectiveness of methods such as mechanical damping through experiments and provide improvement plans for future observations. ### Formula summary: 1. **Phase noise formula**: \[ \phi(t)=\phi_0 + \delta\phi_{sc}(t)=\frac{4\pi}{\lambda}|x_0+\delta x_{sc}(t)| \] where: - \(\phi_0\) is the static phase - \(\delta\phi_{sc}(t)\) is the time - dependent phase change - \(x_0\) is the static path length - \(\delta x_{sc}(t)\) is the time - dependent displacement of the scattering surface 2. **Phase noise spectral density**: \[ h_{ph}(f)=\frac{A\lambda}{8\pi L}F[\sin\delta\phi(t)] \] 3. **Radiation pressure noise (amplitude noise)**: \[ h_{rad}(f)=\frac{A^2\Gamma P}{M L c^2(\Omega^2-\omega^2)}F[\cos\delta\phi(t)] \] where: - \(\Gamma\) is the cavity signal gain - \(M\) is the lens mass - \(P\) is the arm power - \(c\) is the speed of light - \(\Omega\) is the characteristic frequency of the suspension system - \(\lambda\) is the laser wavelength - \(L\) is the arm length (4 kilometers) 4. **Noise peak frequency**: \[ f(t)=\left|\frac{2n v(t)}{\lambda}\right| \] where: - \(n\) is the \(n\)th harmonic (in the case of multiple reflections) - \(v(t)\) is the velocity of the scatterer Through these formulas, researchers can more accurately describe and predict the behavior of scattering noise, thus providing a theoretical basis for noise mitigation measures.

Modeling and Reduction of High Frequency Scatter Noise at LIGO Livingston

Reducing Scattered Light in LIGO's Third Observing Run

Noise in the LIGO Livingston Gravitational Wave Observatory due to Trains

Towards a first design of a Newtonian-noise cancellation system for Advanced LIGO

Environmental Influences on the LIGO Gravitational Wave Detectors during the 6th Science Run

ArchEnemy: Removing scattered-light glitches from gravitational wave data

Gravity Spy: Integrating Advanced LIGO Detector Characterization, Machine Learning, and Citizen Science

Reducing the effect of seismic noise in LIGO searches by targeted veto generation

Characterization of the seismic field at Virgo and improved estimates of Newtonian-noise suppression by recesses

Identification of Resonant Frequencies in LIGO-like Suspension with Finite-Element Modeling

Implications of Dedicated Seismometer Measurements on Newtonian-Noise Cancellation for Advanced LIGO

Passive Newtonian noise suppression for gravitational-wave observatories based on shaping of the local topography

A new method to distinguish gravitational-wave signals from detector noise transients with Gravity Spy

Dual balanced readout for scattered light noise mitigation in Michelson interferometers

VIRGO Newtonian-noise reassessment

Adaptive algorithms for low-latency cancellation of seismic Newtonian-noise at the Virgo gravitational-wave detector

Seismic array measurements at Virgo's West End Building for the configuration of a Newtonian-noise cancellation system

Noise Line Identification in LIGO S6 and Virgo VSR2

Reduction of noise due to scattered light in gravitational wave antennae by modulating the phase of the laser light

Suspensions Thermal Noise in the LIGO Gravitational Wave Detector