Abstract:This paper presents the first systematic study of resolution in compressible, turbulent boundary simulations, and the best-resolved simulation carried out to date. Direct numerical simulation (DNS) and wall-resolved, implicit large-eddy simulation (ILES-NWR) were carried out for a turbulent boundary layer at a Mach number of M=2.3 and maximum momentum thickness Reynolds number of Reθi=2×103. The wall temperature was fixed at a constant value corresponding to the nominal adiabatic wall temperature. The flow was developed spatially from a laminar boundary layer similarity solution specified at the inflow, and transition to turbulence was promoted with an artificial body force trip. The effects of spatial resolution in the range of ILES-NWR, conventional DNS, and very strict DNS were considered. The finest grid in the spatial resolution study consisted of 3.3 × 1010 points, and maintained max(Δx1+,Δx2+,Δx3+)≤1 everywhere. With the resolution at the wall held at (Δx2+)w<1, statistics characterizing large-scale flow features converged for max(Δxi+)≤10, and agreed well with experimental data. Velocity spectra in the outer part of the boundary layer agreed well at low wavenumber for all grids in this range of mesh spacing, and increasing resolution acted to fill out the high-wavenumber end of the spectrum. In all cases, the resolved region of the spectrum agreed well with a well-validated model of the spectrum of isotropic turbulence. Thus, ILES-NWR can be concluded to converge seamlessly to DNS as the spatial resolution is increased. The low-wavenumber aspect of spatial resolution was examined by varying the width of the computational domain, with a fixed level of small-scale resolution. The primary influence of increasing domain width was to capture additional spectral content in low spanwise wavenumbers; other statistics were found to be identical. Further, turbulence statistics were found to be essentially independent of the domain width for values between two and eight times the maximum boundary layer thickness. This work predicts computationally, for the first time, the full velocity spectrum in the outer part of the boundary layer. In doing so, it justifies use of the ILES-NWR approach as long as the maximum grid spacing is less than 10 in inner units, and the domain width is at least two times the maximum boundary layer thickness.

Sensitivity study of resolution and convergence requirements for extended overlap region in wall-bounded turbulence

Higher DNS-resolution requirements for expanded overlap region and confirmation of a convergence criterion

Direct Numerical Simulation of Channel Flow with Real Surface Roughness Using a Ghost Cell Immersed Boundary Method

Utilizing indicator functions with computational data to confirm nature of overlap in normal turbulent stresses: logarithmic or quarter-power

Large Scale Structures Of Turbulent Shear Flow Via Dns

Reynolds number scaling and inner-outer overlap of stream-wise Reynolds stress in wall turbulence

On the streamwise velocity variance in the near-wall region of turbulent flows

Direct numerical simulation of supersonic pipe flow at moderate Reynolds number

Large Eddy Simulations of Turbulent Pipe Flows At Moderate-To-High Reynolds Numbers

Investigating the use of 3-component-2-dimensional particle image velocimetry fields as inflow boundary condition for the direct numerical simulation of turbulent channel flow

Direct numerical simulation of an unsteady wall-bounded turbulent flow configuration for the assessment of large-eddy simulation models

A method for evaluating relations of turbulent normal-stresses by experimental data over a wide range of Reynolds numbers

Resolution effects in compressible, turbulent boundary layer simulations

Direct Numerical Simulation of Wind-Driven Turbulent Flow (investigation of the Computational Accuracy)

One-point statistics for turbulent pipe flow up to $Re_τ \approx 6000$

Evaluation of spatial resolution effects in rough wall-bounded turbulence

Wall Boundary Conditions for RANS Modelling of Unidirectional and Oscillatory Boundary-Layer Flows

Quantifying Uncertainties in Direct-Numerical-simulation Statistics Due to Wall-Normal Numerics and Grids

Asymptotics of stream-wise Reynolds stress in wall turbulence

Large eddy simulations of turbulent pipe flows at moderate Reynolds numbers

Is a direct numerical simulation (DNS) of Navier-Stokes equations with small enough grid spacing and time-step definitely reliable/correct?