Abstract:In this chapter, we review our recent work on first passage time (FPT) problems for absorption by a target whose interface is semipermeable. For pedagogical reasons, we focus on a single Brownian particle searching for a single target in a bounded domain. We begin by writing down the forward diffusion equation for the target problem, and define various quantities of interest such as the survival probability, absorption flux, and the FPT density. We also present a general method of solution based on Green's functions and the spectral decomposition of so-called Dirichlet-to-Neumann (D-to-N) operators. We then use an encounter-based approach to extend the theory to the case of non-Markovian absorption within the target interior. Encounter-based models consider the joint probability density or generalized propagator for particle position and the amount of particle-target contact time prior to absorption. In the case of a partially absorbing target interior, the contact time is given by a Brownian functional known as the occupation time. Finally, we develop a more general probabilistic model of single-particle diffusion through semi-permeable interfaces, by combining the encounter-based approach with so-called snapping out Brownian motion (BM). Snapping out BM sews together successive rounds of partially absorbing BMs that are restricted to either the interior or the exterior of the semipermeable interface. The rule for terminating each round is implemented using encounter-based model of partially absorbing BM. We show that this results in a time-dependent permeability that can be heavy-tailed.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is related to the First Passage Time (FPT) of Brownian particles in an object with a semi - permeable membrane interface. Specifically, the paper focuses on the FPT statistical characteristics of particles being absorbed by the object when the interface of the object is a semi - permeable membrane. Two main situations are discussed in the paper:
1. **Partially Reactive Interface**: As shown in Figure 1(a), the interface of the object is a partially reactive surface. When the particle meets the interface, it is absorbed or reflected back outside the domain with a certain probability.
2. **Semi - Permeable Membrane Interface**: As shown in Figure 1(b), the interface of the object is a semi - permeable membrane, and particles can enter and leave the interior of the object. Inside the object, particles are absorbed at a certain rate.
The main contributions of the paper are as follows:
- **Diffusion Equation and Boundary Conditions**: Derived the forward diffusion equation describing a single Brownian particle searching for a single object in a bounded domain, and defined key quantities such as survival probability, absorption flux, and FPT density.
- **Green's Function and Spectral Decomposition Method**: Proposed a general solution method based on Green's function and the spectral decomposition of the Dirichlet - to - Neumann (D - to - N) operator.
- **Contact Time Model**: Introduced a model based on contact time, considering the influence of the contact time between the particle and the object on the absorption process. This model can handle non - Markovian absorption processes.
- **Model Combining Partial Absorption and Semi - Permeable Membrane**: Combined the contact time model and the so - called "snapping out Brownian motion" to propose a more general probability model for describing the diffusion process of a single particle through a semi - permeable membrane interface.
### Specific Problems and Solutions
1. **FPT Problem of Partially Reactive Interface**:
- **Diffusion Equation**: Outside the object, the diffusion equation of the particle is:
\[
\frac{\partial p(x,t|x_0)}{\partial t} = D \nabla^2 p(x,t|x_0), \quad x \in \Omega \setminus U
\]
- **Boundary Conditions**: On the outer boundary, the particle is completely reflected:
\[
\nabla p \cdot n = 0, \quad x \in \partial \Omega
\]
- **Absorption Conditions**: On the boundary of the object, the particle is absorbed at a certain rate:
\[
D \nabla p(x^+, t|x_0) \cdot n_0 = D \nabla q(x^-, t|x_0) \cdot n_0 \equiv -J(x, t|x_0)
\]
\[
J(x, t|x_0) = \kappa [(1 - \alpha) p(x^+, t|x_0) - \alpha q(x^-, t|x_0)], \quad x^\pm \in \partial U^\pm
\]
2. **FPT Problem of Semi - Permeable Membrane Interface**:
- **Diffusion Equation**: Inside the object, the diffusion equation of the particle is:
\[
\frac{\partial q(x,t|x_0)}{\partial t} = D \nabla^2 q(x,t|x_0) - \gamma q(x,t|x_0), \quad x \in U
\]
- **Boundary Conditions**: On the boundary of the object, the particle flux is continuous but the probability density has a jump discontinuity:
\[
D \nabla p(x^+, t|x_0) \cdot n_0 = D \nabla q(x^-, t|x_0) \cdot n_0 \equiv -J(x, t|x_0)
\]
\[
J(x, t|x_0) = \kapp