Abstract:SOLPS-ITER is used for modeling divertor plasmas in the experimental shot on the EAST tokamak with a carbon divertor. The modeling uses real divertor geometry and an MHD equilibrium from the shot. The modelled divertor configurations include upper single null (USN), disconnected double null (DDN) and lower single null (LSN). D-0, D+1, e(-) and carbon impurity species sputtered from the first wall are included in the multi- fluid simulations. Neutral particles are traced with EIRENE in which neutral-neutral collisions in triangular grids are considered. The default physics models in the code are employed. The cross-field transport coefficients D, chi(e) and chi(i) deduced from the profile measurements at the targets are used with the assumption of chi(i) = chi(e), some of the deduced D are modified in the SOL and private regions and D, chi(e), chi(i) in the core are adjusted in order to match better the experimental measurement at the target plates. Employed D, chi(e) and chi(i) drop from the core to the SOL, they may drop to neoclassic level within the edge transport barriers (ETBs). A ballooning effect on the transport coefficients is introduced. The computational contour profiles of electron temperature in the divertor regions and the computational profiles of plasma pressure and electron temperature at the mid-plane (the upstream) and at the target plate show the sheath limited (low recycling) operation regime. The calculated profiles of electron density n(e), electron temperature T-e, particle flux f, parallel ion saturation current jsat and parallel power flux P along the target plates of the divertor are compared to the experimental measurements. Using the deduced and adjusted cross-field transport coefficients, when the measurement errors are considered the calculated and measured profiles have a relatively good match, the computational profiles are similar to the measured profiles, the profiles peaked at the separatrix strike points. The most peak values f(s) of calculated profiles are in the range of the measured error-bars f(e) +/- d, only in several matched profiles f(s) is out of the range of the errorbar, but, relative error errorp does not exceed 46.55%. When full drifts are taken into account in the entire SOL and the private flux regions the calculated profiles have better match to the measured profiles and the modeling results show the drifts enhance the divertor asymmetry.

Validation of SOLPS-ITER Simulations against the TCV-X21 Reference Case

Validation of SOLPS-ITER Simulations against the TCV-X21 Reference Case

Investigating the influence of divertor baffles on nitrogen-seeded detachment in TCV with SOLPS-ITER simulations and TCV experiments

SOLPS-ITER Modeling of SOL-divertor Plasmas with Different Configurations in EAST

SOLPS-ITER simulation of an X-point radiator in TCV

Performance assessment of a tightly baffled, long-legged divertor configuration in TCV with SOLPS-ITER

Modelling of power exhaust in TCV positive and negative triangularity L-mode plasmas

Dependence of divertor turbulence on plasma density and current in TCV

Self-consistent Simulation of Transport and Turbulence in Tokamak Edge Plasma by Coupling SOLPS-ITER and BOUT++

Prediction of Divertor Heat Flux Width for ITER Using BOUT++ Transport and Turbulence Module

Numerical simulation of neutral gas dynamics in the W7-X sub-divertor

Simulations of the stationary Q=10 and the exit phase from the flat-top of an ITER 15MA baseline scenario Predictive JINTRAC simulations with consistent treatment of D and T in the whole plasma

Corrigendum: Prediction of Divertor Heat Flux Width for ITER Using BOUT++ Transport and Turbulence Module (2019 Nucl. Fusion 59 046014)

Self-consistent multi-component simulation of plasma turbulence and neutrals in detached conditions

Simulation of EAST edge plasma using SOLPS-ITER/BOUT plus plus coupling

Investigation of atomic and molecular rates in plasma-edge simulations through experiment-simulation comparisons

Self‐organization of plasma edge turbulence in interaction with recycling neutrals

Separating the roles of magnetic topology and neutral trapping in modifying the detachment threshold for TCV

Validation of NSFsim as a Grad-Shafranov Equilibrium Solver at DIII-D

Full time-dependent SOLPS-ITER simulation of the SPARC tokamak: Actuator design for particle and divertor condition control

Fluid turbulence simulations of divertor heat load for ITER hybrid scenario using BOUT++