Abstract:Abstract Many aircraft are inherently over-actuated with regard to their input variables. This can be particularly advantageous in the context of unmanned aerial vehicles (UAV), where actuator functions can fail in critical situations. In such cases, the redundant actuators can be used to further fulfil the control strategies used and thus increase the operational safety. Within such an active fault-tolerant control system, a fault detection and isolation (FDI) module is required. To evaluate such safety–critical systems, hardware-in-the-loop simulations (HIL) are a necessary step prior to real flight tests. These simulations can verify the correct implementation of the flight controller on the target hardware as well as the real-time capability of the algorithms used. Particularly in the context of active fault-tolerant control, investigations concerning the robustness of the used FDI module with regard to real, noisy sensor signals, which can be generated by a HIL demonstrator, are of utter importance. This paper presents the development of a HIL demonstrator for the validation of fault-tolerant control methods for a hybrid UAV. This includes a detailed description of the demonstrator’s design, control and interfacing between the integrated subsystems. As an application example, a hybrid UAV model will be shortly presented, which, in addition to the primary aerodynamic control surfaces, can also use four lift rotors to control the aircraft during cruise and is therefore inherently over-actuated. Finally, a closed-loop real-time simulation of the UAV model on the HIL demonstrator is presented on the basis of the exemplary simulation of an actuator failure and subsequent reconfiguration by the fault-tolerant flight control law.

Research on Damage Analysis of Key Parts of UAV Flight Control System

Control reconfiguration design for control surface fault of small unmanned aerial vehicle

Design and Hardware-in-the-loop Simulation of MUAV's Flight Control System

Hardware-In-the-Loop Simulation of UAV for Fault Injection

Active Fault Tolerant Flight Control System Design - A UAV Case Study

Fault-tolerant Control for Unmanned Aerial Vehicle with Wing Damaged

Design of Hardware-In-Loop Simulation System for Unmanned Aerial Vehicle

A Stateflow Based Simulation Of Uav Multi-Mode Flight Control

Simulating Unmanned Aerial Vehicle Flight Control and Collision Detection

Safety Flight Control Design of a Quadrotor UAV With Capability Analysis

Development of a hardware-in-the-loop demonstrator for the validation of fault-tolerant control methods for a hybrid UAV

An Active Fault-Tolerant Control Method for a Low-Cost and Fixed-Wing UAV

Study on Uav Flight State Simulation

A Data Driven Fault Detection And Isolation Scheme For Uav Flight Control System

Typical Fault Estimation and Dynamic Analysis of a Leader-Follower Unmanned Aerial Vehicle Formation

Holistic IJTAG-based External and Internal Fault Monitoring in UAVs

Fault Detection and Tolerant Control for Aero2 2D0F Two-rotor Helicopter

Software- and hardware-in-the-loop verification of flight dynamics model and flight control simulation of a fixed-wing unmanned aerial vehicle

High-Power Microwave Pulse-Induced Failure on Unmanned Aerial Vehicle System

Modeling and simulation of hit accuracy of EFP destruction element under disturbance conditions of UAV

Design And Simulation Of Control System Of Dishing Uav