Number-State Reconstruction with a Single Single-Photon Avalanche Detector

Patrick Banner,Deniz Kurdak,Yaxin Li,Alan Migdall,J. V. Porto,S. L. Rolston
DOI: https://doi.org/10.1364/OPTICAQ.504308
2024-04-12
Abstract:Single-photon avalanche detectors (SPADs) are crucial sensors of light for many fields and applications. However, they are not able to resolve photon number, so typically more complex and more expensive experimental setups or devices must be used to measure the number of photons in a pulse. Here, we present a methodology for performing photon number-state reconstruction with only one SPAD. The methodology, which is cost-effective and easy to implement, uses maximum-likelihood techniques with a detector model whose parameters are measurable. We achieve excellent agreement between known input pulses and their reconstructions for coherent states with up to $\approx$ 10 photons and peak input photon rates up to several Mcounts/s. When detector imperfections are small, we maintain good agreement for coherent pulses with peak input photon rates of over 40 Mcounts/s, greater than one photon per detector dead time. For anti-bunched light, the reconstructed and independently measured pulse-averaged values of $g^{(2)}(0)$ are also consistent with one another. Our algorithm is applicable to light pulses whose pulse width and correlation time scales are both at least a few detector dead times. These results, achieved with single commercially available SPADs, provide an inexpensive number-state reconstruction method and expand the capabilities of single-photon detectors.
Quantum Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to perform photon number - state reconstruction using a single single - photon avalanche diode (SPAD). Traditionally, due to its inability to distinguish the number of photons, SPAD has limitations in applications that require measuring the number of photons in a light pulse. Usually, more complex and expensive experimental setups or devices are required to complete such measurements. This paper proposes a method to achieve photon number - state reconstruction using only one SPAD. This method is low - cost and easy to implement. By combining the maximum - likelihood technique with a detector model whose parameters can be measured, it achieves a good reconstruction effect for coherent - state light pulses (up to about 10 photons) and light pulses with a peak input photon rate of up to several million times per second. In addition, for anti - bunched light, this method can also obtain a pulse average value \(g^{(2)}(0)\) that is consistent with its independent measurement value. This algorithm is applicable to light pulses whose pulse width and relevant time scales are at least several detector dead times. These results indicate that even using a single commercial SPAD can provide an economical and effective method for photon number - state reconstruction and extends the capabilities of single - photon detectors.