Abstract:Superconducting qubits typically use a dispersive readout scheme, where a resonator is coupled to a qubit such that its frequency is qubit-state dependent. Measurement is performed by driving the resonator, where the transmitted resonator field yields information about the resonator frequency and thus the qubit state. Ideally, we could use arbitrarily strong resonator drives to achieve a target signal-to-noise ratio in the shortest possible time. However, experiments have shown that when the average resonator photon number exceeds a certain threshold, the qubit is excited out of its computational subspace in a process we refer to as a measurement-induced state transition (MIST). These transitions degrade readout fidelity, and constitute leakage which precludes further operation of the qubit in, for example, error correction. Here we study these transitions experimentally with a transmon qubit by measuring their dependence on qubit frequency, average resonator photon number, and qubit state, in the regime where the resonator frequency is lower than the qubit frequency. We observe signatures of resonant transitions between levels in the coupled qubit-resonator system that exhibit noisy behavior when measured repeatedly in time. We provide a semi-classical model of these transitions based on the rotating wave approximation and use it to predict the onset of state transitions in our experiments. Our results suggest the transmon is excited to levels near the top of its cosine potential following a state transition, where the charge dispersion of higher transmon levels explains the observed noisy behavior of state transitions. Moreover, we show that occupation in these higher energy levels poses a major challenge for fast qubit reset.

Model-based Optimization of Superconducting Qubit Readout

Model-Based Optimization of Superconducting Qubit Readout

System Characterization of Dispersive Readout in Superconducting Qubits

Stochastic Model of Qudit Measurement for Superconducting Quantum Information Processing

A Simulation Methodology for Superconducting Qubit Readout Fidelity

Optimal Readout of Superconducting Qubits Exploiting High-Level States

Enhancing Dispersive Readout of Superconducting Qubits Through Dynamic Control of the Dispersive Shift: Experiment and Theory

Stochastic modeling of superconducting qudits in the dispersive regime

Quasi-Probabilistic Readout Correction of Mid-Circuit Measurements for Adaptive Feedback via Measurement Randomized Compiling

Integrated Tool Set for Control, Calibration, and Characterization of Quantum Devices Applied to Superconducting Qubits

Improved Superconducting Qubit State Readout by Path Interference

A Co-Simulation of Superconducting Qubit and Control Electronics for Quantum Computing.

Optimizing resetting of superconducting qubits

Quantum optimal control of superconducting qubits based on machine-learning characterization

Benchmarking the readout of a superconducting qubit for repeated measurements

Measurement-Induced State Transitions in a Superconducting Qubit: Within the Rotating Wave Approximation

Readout error mitigated quantum state tomography tested on superconducting qubits

Ultrafast Superconducting Qubit Readout with the Quarton Coupler

Experimental Investigation of an Eight Qubit Unit Cell in a Superconducting Optimization Processor

All-optical single-shot readout of a superconducting qubit

Single-Shot Readout of a Superconducting Qubit Using a Thermal Detector