Abstract:The paper presents the direct power control of doubly fed induction generator (DFIG) under unbalanced and harmonically distorted grid voltage in the stationary frame. Two alternative control targets, the balanced and sinusoidal stator current injected into the power grid, or the smooth DFIG electromagnetic torque to ensure reliable DFIG mechanic parts operation, can be achieved. The complicated and time-consuming grid voltage and stator current negative and harmonic components extraction, as well as power compensation item calculation according to the specific control targets, can be avoided in the proposed control strategy. Moreover, the proposed DPC strategy is implemented in stationary frame, thus no angle of grid voltage fundamental component by phase lock loop (PLL) is required. Therefore, the robustness against grid voltage unbalance and distortion disturbance and better dynamic response capability of the proposed strategy can be essentially ensured. The improved reduced order generalized integrator (ROGI) regulator is employed in stationary frame to regulate the ac signal of -50Hz (stator current negative component), -250Hz and +350Hz (stator current 5th and 7th harmonic component). On the other hand, the electromagnetic torque 100Hz and 300Hz pulsation is eliminated through the effective working of vector PI (VPI) regulators tuned at 100Hz and 300Hz. The availability of the proposed control strategy is validated by the simulation of MATLAB/Simulink.

Direct Power Flow Controller with Continuous Full Regulation Range

Direct Power Flow Controller with Continuous Full Regulation Range

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

Direct Power Control of DFIG System Without Phase-Locked Loop under Unbalanced and Harmonically Distorted Voltage

Coordinated Direct Power Control of DFIG System Without Phase-Locked Loop under Unbalanced Grid Voltage Conditions

Direct Power Control for Dfig under Unbalanced and Harmonically Distorted Grid Voltage in Stationary Frame

Design and Test of UPFC-FCL Prototype.

Multi-switching Table Based Direct Power Control for the Grid-side Converter of Doubly Fed Induction Generator Wind Turbines

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

Direct Power Control of Doubly Fed Induction Generator Without Phase-Locked Loop in Synchronous Reference Frame During Frequency Variations

Single Stage PFC Circuit with Full Bridge Structure

Start-stop Control Strategy for UPFC with Fault Current Limiting

Direct Power Control of Doubly Fed Induction Generator under Distorted Grid Voltage

Multiple Target Implementation for A Doubly Fed Induction Generator Based on Direct Power Control under Unbalanced and Distorted Grid Voltage

Direct Power Control on the DFIG Wind Turbine under Unbalanced Grid Voltage Conditions

Improved Direct Power Control of a Wind Turbine Driven Doubly Fed Induction Generator During Transient Grid Voltage Unbalance

Parameters Design and Example of Unified Power Flow Controller with Fault Current Limiting

A Modular Multilevel Power Flow Controller for Meshed HVDC Grids

Investigation Of Key Technique For High Efficiency And High Power Density, Single-Stage Power Factor Correction Ac/Dc Converter

A Multi-port DC Power Flow Controller Integrated with MMC Stations for Offshore Meshed Multi-terminal HVDC Grids

An Extended Bipole HVDC Structure With Three Wires for Conversion of AC Lines to HVDC