Abstract:We numerically and experimentally demonstrated a higher-order topological state in a three-dimensional (3D) photonic crystal (PhC) with a complete photonic bandgap. Two types of cubic lattices were designed with different topological invariants, which were theoretically and numerically confirmed by the finite difference of their Zak phases. Topological boundary states in the two-dimensional interfaces and hinge states in the one-dimensional corners were formed according to the higher-order of bulk-boundary correspondence. Microwave measurements of the fabricated 3D PhC containing two boundaries and one corner showed a localized intensity, which confirmed the boundary and hinge states.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to realize higher - order topological states, especially hinge states, in three - dimensional photonic crystals. Specifically, the researchers designed two cubic lattice units with different topological invariants and confirmed the Zak - phase differences of these units in the orthogonal directions through theoretical and numerical simulations. When one type of structure is surrounded by another type, according to the high - order bulk - boundary correspondence, topological boundary states and hinge states will be formed at the boundaries and corners. The researchers also verified the existence of these states through microwave measurement experiments. ### Main Problems and Solutions 1. **Problems**: - How to realize higher - order topological states, especially hinge states, in three - dimensional photonic crystals? - How to verify the existence of these topological states through experiments? 2. **Solutions**: - **Theoretical and Numerical Simulations**: Designed two cubic lattice units (Type - I and Type - II) with different topological invariants and confirmed the topological property differences of these units in the orthogonal directions by calculating the Zak - phase. - **Experimental Verification**: Prepared a three - dimensional photonic crystal containing two types of units and observed the localization intensity distributions of the boundary states and hinge states through microwave measurement experiments. ### Specific Steps 1. **Design and Calculation**: - Designed two simple cubic lattice units (Type - I and Type - II), which have different displacements in the x and y directions respectively. - Calculated the photonic band structures of these units using the plane - wave expansion method and confirmed the existence of a complete photonic bandgap (cPBG) within a specific frequency range. - Calculated the Zak - phase and confirmed the topological property differences of the two units in the orthogonal directions. 2. **Experimental Preparation**: - Prepared a three - dimensional photonic crystal containing two types of units, using a polytetrafluoroethylene plate as the material with a thickness of 3.2 mm and a refractive index of 3.5. - Constructed the required three - dimensional structure by drilling holes and pasting columns. 3. **Experimental Measurement**: - Conducted microwave transmission measurements using a network analyzer and measured the spatial distribution of the transmission intensity through loop antennas placed at the bottom and top. - Observed that at a frequency of 9.56 GHz, the intensity was localized at the center position, indicating the existence of hinge states. - Further measured the transmission intensity distributions at different heights and verified the propagation characteristics of the hinge states. ### Conclusion The researchers successfully realized higher - order topological states, especially hinge states, in three - dimensional photonic crystals and verified the existence of these states through experiments. These results provide an important basis for further research and application of the control of high - order topological states in microwave communication and infrared photonic circuits.

Microwave hinge states in a simple-cubic-lattice photonic crystal insulator

All-dielectric photonic crystal with unconventional higher-order topology

Coexistence of All-Order Topological States in a Three-Dimensional Phononic Topological Crystalline Insulator

Higher‐Order Topological States in Surface‐Wave Photonic Crystals

Higher-order photonic topological states in surface-wave photonic crystals

Photonic States on Möbius Band

Higher-order Dirac semimetal in a photonic crystal

3D Hinge Transport in Acoustic Higher-Order Topological Insulators

The Nested Topological Band-Gap Structure for the Periodic Domain Walls in a Photonic Super-Lattice

Direct Observation of Corner States in Second-Order Topological Photonic Crystal Slabs

Photonic Higher‐Order Topological Insulator with Enlarged Non‐Trivial Bandgaps

Adjustable topological corner states in terahertz valley photonic crystals

Magnetic Corner States in a Two-Dimensional Gyromagnetic Photonic Crystal

Topological Edge and Corner States in Biphenylene Photonic Crystal

Higher‐Order States in a Non‐Hermitian 3D Topological Photonic Crystal

Realization of hierarchy topological transition and high-Q response corner state in second-order topological photonic crystal

Higher-order topological states in T-graphene and their realization in photonic crystals

Photonic realization of chiral hinge states in a Chern-insulator stack

Flexible dimensional hierarchy of higher-order topology in the stacked Kagome-chain acoustic crystal

Regularly Multiple Double Dirac Cones in Photonic Bands and Topological Transitions of All-Dielectric Photonic Crystals

Disentangled higher-orbital bands and chiral symmetric topology in confined Mie resonance photonic crystals