Abstract:In quantum illumination (QI) the non-classical correlations between continuous variable (CV) entangled modes of radiation are exploited to detect the presence of a target embedded in thermal noise. The extreme environment where QI outperforms its optimal classical counterpart suggests that applications in the microwave domain would benefit the most from this new sensing paradigm. However all the proposed QI receivers rely on ideal photon counters or detectors, which are not currently feasible in the microwave domain. Here we propose a new QI receiver that utilizes a CV controlled not gate (CNOT) in order to perform a joint measurement on a target return and its retained twin. Unlike other QI receivers, the entire detection process is carried out by homodyne measurements and square-law detectors. The receiver exploits two squeezed ancillary modes as a part of the gate's operation. These extra resources are prepared offline and their overall gain is controlled passively by a single beamsplitter parameter. We compare our model to other QI receivers and demonstrate its operation regime where it outperforms others and achieves optimal performance. Although the main focus of this study is microwave quantum sensing applications, our proposed device can be built as well in the optical domain, thus rendering it as a new addition to the quantum sensing toolbox in a wider sense.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is how to design a new receiver in Quantum Illumination (QI) to overcome the problem that existing receivers cannot achieve an ideal single - photon counter in the microwave domain. Specifically, the paper proposes a new QI receiver based on the Continuous Variable (CV) Controlled - NOT (CNOT) gate. This receiver can perform joint measurements using CV CNOT operations without an ideal single - photon counter, thereby extracting non - classical correlations between the signal - idler modes and improving detection performance.
### Background and Problem Description of the Paper
Quantum illumination is a technique for detecting targets embedded in thermal noise using non - classical correlated electromagnetic radiation modes. Under low Signal - to - Noise Ratio (SNR) conditions, quantum illumination has significant advantages over its optimal classical counterpart, especially in the microwave domain. However, existing QI receivers rely on ideal single - photon counters or detectors, which are currently difficult to achieve in the microwave domain.
### Solution Proposed in the Paper
The paper proposes a new QI receiver that uses the CV CNOT gate to perform joint measurements without the need for an ideal single - photon counter. Specifically, the working principle of this receiver is as follows:
1. **CV CNOT Gate Operation**: The receiver uses two squeezed ancillary modes (one position - squeezed and the other momentum - squeezed) as part of the CNOT gate operation. The overall gain is controlled by a single beam - splitter parameter, enabling the receiver to optimize performance in different operating domains.
2. **Joint Measurement of Signal - Idler Modes**: When receiving a small initial correlation of the target return signal, the CNOT receiver enhances these correlations through a controllable interaction gain. If these correlations are lost, the receiver outputs an uncorrelated noise beam.
3. **Detection and Analysis**: The signal level is determined by homodyne detection and a square - law detector. Since the quadrant averages of the TMSV mode are necessarily zero, the output homodyne current is sent to a square - law detector, such as a Spectrum Analyzer (SA), to overcome this problem.
### Performance Analysis
The paper analyzes in detail the performance of the new receiver and compares it with existing OPA, PC, and SFG receivers. The main conclusions are as follows:
- **Cross - Correlation of Signal - Idler Modes**: The new receiver can effectively extract the cross - correlation between the signal - idler modes, which is a key feature of quantum illumination.
- **Gain Control**: By controlling the gain of the CNOT gate, the receiver can enhance the correlation between the signal - idler modes, thereby improving detection performance.
- **Background Noise**: The paper considers the influence of background noise on system performance and derives the expression for the noise power of the receiver, further calculating the Bit Error Rate (BER) of the receiver.
### Conclusion
The QI receiver based on the CV CNOT gate proposed in the paper provides a new solution in the microwave domain. It can effectively extract the non - classical correlation between the signal - idler modes without an ideal single - photon counter, thereby improving the performance of quantum illumination. This scheme is not only applicable to the microwave domain but can also be implemented in the optical domain, providing a new tool for quantum sensing technology.